dreo Nomad One User manual

DREO
Tower Fan
USER MANUAL
(N

Thanks for
Choosing
DREO!
Your support means the world to us. We
hope you enjoy our product as much as
we did creating it.

EXTEND
YOUR WARRANTY
FOR FREE
Scan or visit dreo.com/warranty to extend your warranty for
free by registering your product. If you have any product issues,
we always stand ready to help.
@ (s88) 290-1688
Mon - Fri, 9:00 am-5:00 pm PST/PDT
@ [email protected]
@ www.dreo.com
FOLLOW US TO
DISCOVER MORE
Find us on social media to stay connected and find
new inspiration.
Join the Dreo community on Facebook:
facebook.com/groups/dreohome (‘)
@ ® © @Dreo

CONTENTS
IMPORTANT SAFETY
INSTRUCTIONS
1-2
ASSEMBLING YOUR
TOWER FAN
3-5
KNOWING YOUR
USING YOUR TOWER
TOWER TOWER FAN
FAN
6-7 8-10
CLEANING TROUBLESHOOTING
AND MAINTENANCE
1-13
14
DREO CUSTOMER
CARE
15

IMPORTANT SAFETY
INSTRUCTIONS
READ ALL CAUTIONARY
NG ORTE AR PN Do not coverthe Do not use the fan
AND SAFETY INSTRUCTIONS airinlet and outlet near flammables
IN THE USER MANUAL BEFORE while in operation. and combustibles.
USE.
General Safety
Children shall not play with the appliance. Cleaning and maintenance shall
not be performed by children without supervision.
n Use the appliance as described in the user manual only. Any other use
not recommended in the user manual may cause fire, electrical shock, or
personal injury.
w This appliance can be used by children aged above 8 years and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or instruction
concerning use of this appliance in a safe way and understand the
hazards involved.
Operation Safety
1. Place the appliance on a flat, dry surface before use.
2. Do not immerse in water and any other liquids.
3. Do not use the appliance until the base is installed.
4. Do not insert your fingers, pencil and any other objects into the grilles
while in operation.
5. Do not dismantle, repair, or modify. All servicing should be performed by
qualified personnel.

Electricity Safety
1. Make sure that the voltage of your electricity supply s the same as that
indicated on the appliance.
2. Always unplug before cleaning or leaving the appliance unused for a long
period of time. Keep your hands dry when plugging/unplugging.
3. Do ot operate any fan with a damaged cord or plug. Discard fan or retumn
to an authorized service facility for examination and/or repair.
4. Do not run cord under carpeting. Do not cover cord with throw rugs,
runners, or similar coverings. Do not route cord under furniture or
appliances. Arrange cord away from traffic area and where it will not be
tripped over.
o . WARNING: To reduce the risk of fire or electric shock, do not use this
tower fan with any solid-state speed control device.
o . This appliance employs overload protection (fuse). A blown fuse indicates
an overload or short-circuiit situation. If the fuse blows, unplug the product
from the outlet. Replace the fuse as per the user servicing instructions.
and check the appliance. If the replacement fuse blows, a short-circuit
may be present and the appliance should be discarded or returned to an
authorized service facility for examination and/or repair.
7. This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug s intended to fit in a polarized
outlet only one way, If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician. Do not attempt to
defeat this safety feature.
FOR HOUSEHOLD USE ONLY READ
AND SAVE THESE INSTRUCTIONS
Gentle Reminder: Specifications
Check the appliance regularly I ERARE
and refer to TROUBLESHOOTING
QP ) o contact our customer support Input AC120V 60tz
ifit shows any of the following
- S Rated Power 42w
~Power cord or plug s damaged.
- Loud noise, unusual smell or excessive heat. Battery Type CR2025

ASSEMBLING
YOUR TOWER FAN
Assembly Instructions
When using the appliance for the first time, remove the wraps and attach the
parts by following the steps below.
Keep two base halves in a
crossed position, then insert
pegs on one half onto the
slots on the other half.
Press down on edges to click two Run the cord through the center
base halves together. hole.

Fit the base onto the bottom of Rotate the base clockwise to
the fan by aligning the arrows lock in place.
on the underside.
Thread the cord through the cord
keepers before putting the fan upright.
CAUTION
- Do not operate the tower fan if the base has not been installed.
- Make sure to thread the cord through all rear cord keepers.

Package Contents
Control | LED Display
Panel
Quick start
Mandal Glide
Remote Control
Air
Outlet
(Battery
included)
Power & Plug oy
Handle
m
5~
Remote
Holder
)
Base
Air Inlet

KNOWING YOUR
TOWER FAN
Control Panel
Mode Button
Switch between Normal/Natural/Sleep/Auto Mode
Fan Speed Button
Adjust airflow volume (1-4 levels)
Power Button
Turn power on/off
Timer Button
Select to set a timer (0-8h)
Oscillation Button
Adjust airflow direction

LED Display
e
[
Fan Speed/ Timer Hour
) —~
29 12 @ AUTO
= -
Normal Mode Natural Mode Sleep Mode Auto Mode
' C
Oscillation
NOTE:
- Display will turn off after 1 minute (after 5 seconds in sleep mode).
- Wake up the display with any button.
- Display will not turn off when the auto on timer is enabled.
Getting the Most out of
Your Tower Fan
1. It's not an air conditioner.
2. Remove any tall obstacles that might block
the airflow from the fan.
3.Combine with your AC unit to get cooler air
throughout the room.
Position the tower fan closer to you to get
more direct airflow.
Place a bucket of ice in front of the fan for
an extra cooling boost.

USING YOUR
TOWER FAN
General Operations
Touch @) to turn on, and &)
to choose a working mode.
Touch @ to adjust the
airflow volume.
Touch © to change the
airflow direction.
e Touch @ tosetatimer.
Touch (@) to turn off the
tower fan.
Working Modes
Sleep Mode Auto Mode
(Mute Auto On) Fan speed adapts to the
ambient temperature.
Fan speed decreases every
30 minutes.
Speed decreases by two levels Normal Mode
at most and will remain constant Fan runs at the constant speed.
if at level 1
For level 4: 4 32
b O
For lovel 1 Fan runs at alternating speeds.

Additional Features
Timer
Mute
Memory
When the fan is ON/OFF, touch the timer button (O
repeatedly to set a timer from 1to 8 hours. When
the timer ends, the fan will stop/start running
automatically. To cancel, set the time to O hour.
Note: When the auto off timer is enabled, display wil return
tofan speed after 3 seconds.
Method 1: Short press the mute button K[* on
the remote control to turn oroff button
sounds.
Method 2: Long press the mode button () on the
control panel to turn onoff button sounds.
If the fan is turned OFF or disconnected from power,
it will operate under the previous settings (except
the timer setting) when it is turned ON again.
Remote Control
Power Indicator
Decrease Fan Speed
Mode
Oscillation
Power
Mute
ISewy
Timer
Increase Fan Speed

Battery Replacement
@ Press the locking button to pop
out the battery holder.
@ Replace with the same battery
type with the (+) side facing up.
© Push in the holder until securely
locked into place.
Note: If the indicator on the remote
control doesn't turn on any more,
please consider replacing the
battery.
WARNING
Chemical Burn Hazard. Keep batteries away
from children.
This product contains a lithium buttonicoin cell battery. If a new or
used lithium button/coin cell battery is swallowed or enters the body,
it can cause severe internal burns and can lead to death in as ittle
as 2 hours. Always completely secure the battery compartment. If
the battery compartment does not close securely, stop using the
product, remove the battery, and keep it away from children. If you
think batteries might have been swallowed o placed inside any part
of the body, seek immediate medical attention.
The cells must be disposed of properly, including keeping them
away from children. Even used cells may cause injury.

CLEANING AND
MAINTENANCE
Outer Surface
Gently wipe off the dust with a soft,
dry cloth.
Press on the lock sign here and rotate
counterclockwise to release the base
from the fan, then press the tabs on the
edges to detach the base halves from
each other.
CAUTION
1. Always unplug the fan before any cleaning or maintenance
to avoid the risk of fire, electric shock, or injury to persons.
Do not immerse in water or get water inside the motor
housing.
3.Do not use any chemical agents when cleaning the fan.
4.Store in a cool, dry place and cover it to protect from dust.
1

Rear Grille
WARNING
Turn off the appliance and unplug before any cleaning and
maintenance.
s
H Remove the screw on the top of the rear
grille with a Philips screwdriver.
‘ é Lift up the grille and pull it out.
Clean the dust on blades using a
vacuum cleaner or air duster.
Rinse the rear grille under running
water or with a clean, damp cloth.
-
@ D7y.up: then install the grile and the screw back by following the
reverse order of disassembly.

User Servicing Instructions (Fuse)
This appliance features a fused safety plug that protects against overioad or
short-circuit situations. If the fuse blows, please cut off power and follow the
below instructions or consult a qualified electrician.
Grasp plug and remove from the receptacle or other outlet device. Do
not unplug by pulling on cord.
Open fuse cover. Slide open fuse access cover on top of attachment.
plug towards blades.
Remove fuse carefully. Push the fuse from the other side to remove
the fuse.
Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse.
Close fuse cover. Slide closed the fuse access cover on top of
attachment plug.
WARNING
Risk of fire. Do not replace attachment plug. Contains a
safety device(fuse) that should not be removed. Discard
product if the attachment plug is damaged.

TROUBLESHOOTING
My fan won't turn on!
1. Make sure that the cord is connected to a powered outlet and the
mains voltage corresponds with the voltage indicated on the fan.
2. Check if the fuse has blown. If the fuse has blown, please refer to
page 13.
My fan is shaky and wobbling!
1. Place the fan on a flat, level surface.
2. Incorrect installation might also cause shakiness. Please refer to
the assembly instructions in page 3-4. Note that the power cord
must be run through all three keepers.
My fan is making vibration and noise!
1. Place the fan on a flat, level surface.
2.Be sure not to insert anything into the air inlet and outlet.
If your problem is not listed or still persists, please contact our
Customer Support (see page 15).

DREO CUSTOMER
CARE
Default 12-Month Warranty
This appliance is covered by Dreo warranty for 12 months from the date of
its original purchase.
Extend Your Warranty
Extend your warranty by registering your new appliance on our website
https:/dreo.com/warranty.
The warranty will not apply in cases of:
1. Accident, misuse, or repairs performed by unauthorized personnel.
2. Any unit that has been tampered with or used for commercial purposes.
3. Normal wear and tear of wearable parts.
4. Use of force, damage caused by external influences.
5. Damage caused by non-observance of the User Manual, e.g. connection
to an unsuitable mains supply or noncompliance with the instructions.
6. Partially or completely dismantled appliances.
7. Defects caused by or resulting from damages from shipping or from
repairs, service, or alteration to the product or any of its parts that have
been perform ed by a repair person not authorized by Dreo.
We can only provide after-sales service for products that are sold by Dreo
or Dreo authorized retailers and distributors. If you have purchased the
appliance from a different place, please contact your seller for return and
warranty issues.
@ (s88)290-1688 @ [email protected] @ www.dreo.com
Mon - Fri, 8:00 am-5:00 pm PSTPDT
e]‘b us.
@ www.dreo.com
Shenzhen Hesung Innovation Technology
Co, LTD
Intertek
9 26F, Bldg A7, Creative City, Shenzhen, China MADE IN CHINA 5018396
Rev_1.6_EN 15—

www.dreo.com
DR-HTFOO7
Looking for help?
Contact us to get expert support.
@ [email protected] @ [phone] @ www.dreo.com
Mon - Fi, :00 am-5:00 pm PSTRDT