Drumond Park Bubble Buster User manual

Use a cross-head screwdriver to turn the battery compartment
screws anti-clockwise. Remove the battery compartment
covers.
Insert 4 AA [LR06] batteries into the bubble blower with the
polarities as shown. Insert 2 AAA [LR03] batteries into each
wand with the polarities as shown.
Replace the battery compartment covers and tighten the
screws gently.
BATTERY INSTALLATION
20200403a
Ref No. T73117
IMPORTANT:
• Do not use rechargeable batteries
• Batteries must be removed and inserted under adult supervision
• Do not attempt to recharge non-rechargeable batteries
• Take special care to ensure batteries are inserted correctly, observing (+) and (-) marks
on battery and product
• Remove exhausted batteries from product and dispose of properly
• Do not short-circuit the supply terminals
• Do not mix old (used) and new batteries or batteries of different types, e.g. alkaline,
standard (carbon-zinc), rechargeable (e.g. NiMH), or batteries of a different make/brand
• Do not dispose of batteries in fire as they may explode or leak
The wheelie bin symbol indicates the product and batteries must not be disposed
of in domestic waste as they contain substances damaging to the environment and
health. Please use collection points or recycling facilities.
©2019 Drumond Games Ltd. Made under license from The Merlin Group.
Colour and contents may vary from those shown.
Please retain this information for future reference.
Made in China.
WARNING! CHOKING HAZARD - Small parts.
Not for children under 3 years.
See more fun games at www.drumondpark.com
CONTENTS:
2 Bubble Buster Wands, Bubble Blower, Bubble Buster liquid
TO ENJOY BUBBLE BUSTER, PLEASE
READ THESE IMPORTANT NOTES:
1. Before starting it helps to rub a little bubble liquid over the balls
at the ends of the wands' antennas so it PINGS more easily.
2. Not all burst bubbles will make a PING noise. The slower and
more deliberate the movement to prod and burst a bubble, the
more likely it will PING.
3. The very best way to make a PING is to "catch" the bubble
between the antennas, then twitch the wand to burst it.
4. If the wand makes a continuous noise, the head needs to be
wiped clean of bubble liquid. The wands may also need a few
minutes to dry thoroughly.
INSTRUCTIONS
AGE 4+ For 1-2 players
The contents are expressly designed for the purpose described and
shown, neither should be placed in or near water, they are electronic
and will not withstand repeated mistreatment.
WARNING: Residue from the blown bubbles can cause the surface
below the blower to become slippery.

1
2
OFF
ON
3
4
Game Play
Press the button on the top of the bubble blower [pic 4]
to start the bubbles blowing. When you want to switch off
the blower press this button again.
The two players must start bursting bubbles as quickly as possible.
The game is a race to see who can be the first to burst 20 magic
pinging bubbles. Make sure both silver antennas touch the bubble
when you burst it or the wand will not count it.
When you burst a magic pinging bubble the wand makes a "ping"
noise. As you burst more magic pinging bubbles, the "pings" get
higher in pitch.
Winning
When you burst the 20th magic pinging bubble the wand makes a
chime with several notes to let you know that YOU are the winner! If
both players' wands chime at the same time the game is a draw.
Starting a new Game
Switch both wands off and on again to start a new game.
If you don't pop any bubbles for three minutes, the wand will switch itself off,
touch a magic pinging bubble to switch it on again.
Wand
If you get a repeating sound, switch off the wand. Clean the head and silver
antennas with a damp cloth then dry it before switching on again.
Please dry the wand and antennas before putting them away.
Did you know that bubbles evaporate? So the earlier you touch them the
better the chance of finding that magic PING noise.
Blower
If the blower is not blowing bubbles consistently, top up the fluid.
Do not stop the blower arms going round while it is switched on.
If the blower is used outside and there is a light wind, face the blower so it
blows the same direction as the wind [pic 5].
Always pour the remaining bubble liquid back into the bottle after use. There
is a spout on the bottom edge of the blower opening [pic 6] to help pour
cleanly. Always wipe dry before putting away.
For best results place blower unit approx 800mm off ground level.
Safety recommendations for bubble solutions:
Use bubble solutions specifically designed for children. These products
contain less surfactants, fragrances and other ingredients which may cause
irritation to a child.
Do not allow your child to play with undiluted solutions. Undiluted solution is likely
to have an increased irritation potential, particularly with a young child’s eyes.
Swallowing large amounts of bubble solutions, particularly if undiluted, may
cause vomiting and irritation to the mouth and throat.
Getting Ready to Play
An adult should install the batteries - see the back page.
Take the white "eyes" panel off the front of the bubble blower [pic 1]
and fill the bowl with bubble solution [pic 2].
Switch on each wand [pic 3]. When you burst your first magic pinging
bubble the wand will make the first "ping" and the red light on the
handle will come on to show you have enough battery power [pic 3].
Pour into front
compartment
65