330ARP
After the laminator has been turned on using the tempera-
ture transfer switch located on “0” position, the cold mode
is automatically set. If the machine has just recently been
used for hot lamination, then the machine must reach a
temperature of no more than 25 before starting cold
lamination.
C
WARNING：
For your protection, do not connect the pouch laminator to electrical
power until you read this instruction completely. Keep this instruction in a
convenient location for future reference.
A3 LAMINATOR
Heating system Hot shoe + heating plate
Laminating type Cold & hot laminating
Laminating speed 750~800mm/min
Laminating thickness 1mm
Warm up time 3~3.5min
Roller quantity 4
Max. entrance width 330mm
Available thickness 75~250mic
1.
4.
Instruction Manual
COLD Lamination
Cautions item:
Cleaning
Service:
Technology data
1. Select a no-heat laminate that is slightly large than the document to be laminated.
2. Run the film, film-side faced up, for about 3~6mm into the laminator, and then press POWER BUTTON
to stop the rollers.
3. Carefully separate the baking release paper from the film, and drape the clear film over the top of the
laminator.
4. Place the document between the separated film and backing.
5. Then press the power switch to finish laminating.
Toensuresafetyandpreventseriousaccidents,suchascrispateofpouchorfire,pleaseobeythe
followingstepscompletely.
1.Toavoidthedangerofelectricalshock,keepthemachineawayfromwatersourcesoranywet
conditions.
2.DonotlaminatingitemssuchasDrawingsontheheat-sensitivepaperormatterwhosecoloror
qualityispronetochangewhenheating.
3.Interlayerwhichisthickerthan1.0mmisnotsuitableforlamination.
4.Thepouchesshouldn’tbelargethanA3paper.
5.Donotlaminateeasymelting,stickyobjectsandobjecttoosoftaswellasthinnerpaper.
6.Forprolongingtheroller’slife,youshouldrevolvethe
Temperaturetransferswitch
to“0”
positionafterfinishedhotlaminatingandturnoffthe
powerswitchabouttenminuteslater.
Warning :please make sure that the machine has been turned off and unplugged before cleaning.
As to the smutch on the covers of the machine, please wipe them off by cloth.
Do not attempt to service or repair the pouch laminator yourself. Unplug the unit and contact an
authorized service representative for any required repairs.
。
