DSE 8721 User manual

ACCESSING THE FRONT PANEL CONFIGURATION EDITOR.
•
Ensure the engine is at rest and the module is in STOP mode by pressing the
Stop/Reset button. Press the Stop/Reset and Info buttons
simultaneously.
•
If a module security PIN has been set, the PIN number request is then shown :
•Press the button the first digit will flash to enable the pin to be entered.
•Press (up) or (down) to adjust it to the correct value.
•Press (right)
when the first digit is correctly entered. The digit you have
just entered will now show ‘#’ for security.
•
Repeat this process for the other digits of the PIN number. You can press
you need to move back to adjust one of the previous digits.
•When
is pressed after editing the final PIN digit, the PIN is checked for
validity. If the number is not correct, you must re-enter the PIN.
If the PIN has been successfully entered (or the module PIN has not been enabled),
the editor is displayed :
EDITING A PARAMETER
•Enter the editor as described above.
•Press the or to cycle to the parameter
you
wish to view/change.
•To edit the parameter, press to enter edit mode. The parameter is
highlighted in blue to indicate that you are editing the value.
•Press or down
buttons to change the parameter to the required
value.
•Press to save the value.
The parameter ceases flashing to indicate that it
has been saved.
•To exit the editor at any time, press and hold the or button.
ISSUE 1
DIMENSIONS AND MOUNTING
For flat surface mounting in a Type 1 enclosure to meet UL requirements
DIMENSIONS
310.0mm x 161.5mm x 42mm (12.2” x 6.4” x 1.6”)
PANEL CUTOUT
282mm x 136
DEEP SEA EL ECT RON I C S
8721
INST ALLATION INSTRUCTIONS
Ensure the engine is at rest and the module is in STOP mode by pressing the
If a module security PIN has been set, the PIN number request is then shown :
when the first digit is correctly entered. The digit you have
Repeat this process for the other digits of the PIN number. You can press
(left) if
is pressed after editing the final PIN digit, the PIN is checked for
If the PIN has been successfully entered (or the module PIN has not been enabled),
you
buttons to change the parameter to the required
The parameter ceases flashing to indicate that it
For flat surface mounting in a Type 1 enclosure to meet UL requirements
PANEL CUTOUT
:
282mm x 136
mm (11.1” x 5.4”)
DEEP SEA EL ECT RON I C S
INST ALLATION INSTRUCTIONS
053-072
ISSUE 4

ACCESSING THE ‘RUNNING’ CONFIGURATION EDITOR
•The ‘running’ editor can be entered while the engine is running. All protections
remain active if the engine is running while the running editor is entered.
•Press and hold the button to enter the running editor.
ADJUSTABLE PARAMETERS (Running editor)
•Enter the editor as described above.
• Press the up or down buttons to cycle to the section you wish to
view/change.
• To Edit the parameter press the button to enter edit mode. The parameter
begins to flash to indicate that you are editing the value.
•Press the up or down buttons to change the parameter to the
required value.
•Press the button to save the value. The parameter ceases flashing to
indicate that it has been saved.
•To exit the editor at any time , press and hold the button.
Deep Sea Electronics
Plc.
Tel:[phone]
Fax: [phone]
Email: [email protected]
Web: www.deepseaplc.com
Deep Sea Electronics inc.
Phone: [phone]
Fax: [phone]
TOLL FREE (USA only) : Tel: [phone]
9703
Email: [email protected]
Web: www.deepseausa.com