DTY INDOOR LIVING Cortez IF-1060 User manual

Cortez Stool www.DTYStore.com Page 1of 6
Cortez Stool
Item No. IF-1060, IF-1061, IF-1062, IF-1063, IF-1064,
IF-1065, IF-1066, IF-1067
Made in Vietnam
For assistance with assembly, please contact DTYStore.com Customer Satisfaction Center
866-217-8155 . [e-mail]

Cortez Stool www.DTYStore.com Page 2of 6
Pre-Assembly Instructions
•Read all instructions carefully before assembly.
•Find a smooth clean area in which to work to avoid damaging your item.
•Check that all parts and hardware from the lists are present.
•Lay out parts in alphabetical order and hardware in numerical order to make them easier to
find when you are ready to assemble
•Wait to dispose of packing material until assembly is complete to avoid accidentally
disposing of small parts or hardware
•Tools required: Hex wrench (included) Phillips Screwdriver (not included)
•Please use caution and care when lifting the product to avoid injury
•For ease of assembly two people are recommended
Parts List:
Hardware List:
44
A. Seat Qty:1
B. Left Leg Qty: 2
C. Right Leg Qty: 2
D. Footrest Qty: 2
E. Side Stretcher Qty: 2
1. 2 3/18” Bolt Qty: 8
2. Spring Washer QTY: 8
3. Flat WasherQty: 8
4. Hex Wrench Qty: 1
5. Screw Qty: 8

Cortez Stool www.DTYStore.com Page 3of 6
Assembly Instructions:
Step 1
Wait to fully tighten all hardware until the end of Step 2.
A. Place Seat (A) upside down on a soft surface. Use two Bolts (H1), two Spring
Washers (H2), and two Flat Washers (H3), to loosely attach Right Leg (C) to
Seat (A).
TIP: Leg should line up perfectly with the apron of the chair, if there are any
gaps between the leg and the seat frame, the leg is in the wrong corner
A. Use two Bolts (H1), two Spring Washers (H2), and two Flat Washers (H3), to
loosely attach Left Leg (B) to Seat (A).
B. Place Side Stretcher (E) in the slot on Right Leg (C), and in the slot on Left Leg
(B) Be sure the screw slots are facing up.
C. Tighten the bolts on Right Leg (C) and Left Leg (B)
3
3
2
1
4
2
1
4

Cortez Stool www.DTYStore.com Page 4of 6
Step 2
A. Use two Bolts (H1), two Spring Washers (H2), and two Flat Washers (H3), to
loosely attach second Right Leg (C) to Seat (A).
B. Place Footrest (D) in the slot on Left Leg (B), and in the slot on the second Right
Leg (C) Be sue the metal footplate faces the seat and the screw slots face up.
C. Tighten the bolts on Right Leg (C)
A. Place Side Stretcher (E) in the slot on Right Leg (C), and in the slot on second
Left Leg (B)
B. Use two Bolts (H1), two Spring Washers (H2), and two Flat Washers (H3), to
loosely attach Left Leg (B) to Seat (A).
C. Place Footrest (D) in the slot on Left Leg (B), and in the slot on the Right Leg (C)
Be sue the metal footplate faces the seat and the screw slots face up
D. Fully tighten all bolts
3
2
1
4
3
2
1
4

Cortez Stool www.DTYStore.com Page 5of 6
Post-Assembly Instructions:
•Periodically check hardware to be sure they do not loosen overtime.
•Do not stand on stool or stretchers.
Step 3
A. Use two Screws (H5), to attach Side Stretcher (E) between Right Leg (C) and Left
Leg (B)
TIP: Press both legs against the Side Stretcher bar, until you get the screws
started. Make sure the stretcher bar is flush (no gaps) against the leg, this
will also help with stabilization. Tighten the screws fully.
B. Use two Screws (H5), to attach Footrest (D) between Right Leg (C) and Left Leg
(B)
TIP: Press both legs against the Side Stretcher bar, until you get the screws
started. Make sure the stretcher bar is flush (no gaps) against the leg, this
will also help with stabilization. Tighten the screws fully.
C. Repeat with remaining side stretcher and footrest.
5
5

Cortez Stool www.DTYStore.com Page 6of 6
Furniture Care Tips
With proper care your furniture will look beautiful for years to come.
•Avoid placing in direct sunlight to keep from fading and discoloring.
•Do not use soap or abrasive cleaners
•Use a soft damp cloth to remove normal dust and dirt, then dry with a clean cloth until
completely dry.
•Clean up spills as soon as they occur by blotting the food or liquid and then by wiping
with a damp cloth
•A good quality leather cleaner and conditioner may be used periodically following their
instructions.
•Wood furniture should be dusted frequently. Use a lamb's wool duster, microfiber
cleaning cloth or cotton cleaning cloth.
•Dusting with a dry cloth can scratch your furniture so lightly spritz your duster with water,
a spray duster or wood polish.
•Never spray polish directly on the furniture as it can cause furniture products to buildup.
•Dust in the direction of the grain