DTY OUTDOOR LIVING Longs Peak OF-1004 User manual

Longs Peak Eucalyptus Side Table OF-1004
www.DTYStore.com
Page 1of 4
Longs Peak Deep Seat Side Table
Item No. OF-1004
Made in Vietnam
For assistance with assembly, please contact DTYStore.com Customer Satisfaction Center
866-217-8155 . [email protected]

Longs Peak Eucalyptus Side Table OF-1004
www.DTYStore.com
Page 2of 4
Pre-Assembly Instructions
Read all instructions carefully before assembly.
Find a smooth clean area in which to work to avoid damaging your item.
Check that all parts and hardware from the lists are present.
Lay out parts in alphabetical order and hardware in numerical order to make them easier to find when
you are ready to assemble
Wait to dispose of packing material until assembly is complete to avoid accidentally disposing of small
parts or hardware
Tools required: Hex wrench (included)
Please use caution and care when lifting the product to avoid injury
For ease of assembly two people are recommended
Parts List:
A. Top Qty: 1
B. Leg 1 Qty: 2
C. Leg 2 Qty: 2
D. Lower Shelf Qty: 1
Hardware List:
1. Washer Qty: 8
2. Screw Qty: 12
3. Hex Wrench Qty: 2

Longs Peak Eucalyptus Side Table OF-1004
www.DTYStore.com
Page 3of 4
Step 1:
Place the Top (A) upside-down on a flat surface.
Set the Legs near the corners of the Top so the Legs (B) are at opposite corners from Legs (C).
Note: Insert all Screws (2) only half-way - wait to tighten until the end of Step 2.
Use Screws (2), Washers (1) and Hex Wrench (3) to loosely attach the Legs (B) and Legs (C) in the
corners of the Top.
Item
Drawing
Qty
1
8
2
8
Step 2:
Insert four Screws (2) by hand to hold the Lower Shelf (C) to the Legs (B) and Legs (C).
Once these four Screws have been inserted, tighten all 12 Screws.
Turn the table upright.
Item
Drawing
Qty
2
4

Longs Peak Eucalyptus Side Table OF-1004
www.DTYStore.com
Page 4of 4
Post-Assembly Instructions:
Periodically check fasteners to be sure they do not loosen over time.
Do not stand or sit on this item.
Outdoor Furniture Care Instruction:
With the proper care your premium eucalyptus furniture will last up to 25 years or more. For unfinished furniture,
we suggest lightly sanding the surface of the furniture with 150 or 180 grit sandpaper once a year to remove any
fuzziness and any larger splinter causing fibers that occur due to exposure to the elements. Be sure to sand
lightly to retain the natural patina. Furniture with an oil finish should also be treated yearly with a light coat of
wood oil designed for eucalyptus or teak by applying it with a soft cloth. For finished furniture, we recommend
brushing off any loose dirt or debris with a soft brush and wiping down with a mild detergent and water. We
recommend you protect your furniture in the off season by using a using a good quality furniture cover. It helps
keep your furniture clean and protects it from the elements thus minimizing annual maintenance.