DTY OF-1002 User manual

Longs Peak Console Table OF-1002
www.DTYStore.com
Page 1 of 4
Longs Peak Console Table
Item No. OF-1002
Made in Vietnam
For assistance with assembly, please contact DTYStore.com Customer Satisfaction Center
866-217-8155 . [email protected]

Longs Peak Console Table OF-1002
www.DTYStore.com
Page 2 of 4
Pre-Assembly Instructions
Read all instructions carefully before assembly.
Find a smooth clean area in which to work to avoid damaging your item.
Check that all parts and hardware from the lists are present.
Lay out parts in alphabetical order and hardware in numerical order to make them easier to find when
you are ready to assemble
Wait to dispose of packing material until assembly is complete to avoid accidentally disposing of small
parts or hardware
Tools required: Hex wrench, wrench (included)
Please use caution and care when lifting the product to avoid injury
For ease of assembly two people are recommended
Parts List:
A. Top Qty: 1
B. Leg 1 Qty: 2
C. Leg 2 Qty: 2
D. Lower Shelf Qty: 1
Hardware List:
1. Washer
Qty: 8
2. Hex Nut
Qty: 8
3. Screw
Qty: 4
4. Wrench
Qty: 1
5. Hex Wrench
Qty: 1

Longs Peak Console Table OF-1002
www.DTYStore.com
Page 3 of 4
Assembly Instructions:
Step 1:
Place the Top (A) upside-down on a flat surface.
Set the Legs near the corners of the Top so the Legs (B) are at opposite corners from Legs (C).
Use Washer (1) and Hex Nut (2) to secure the Legs. Tighten all Hex Nuts with the Wrench (4).
Item
Drawing
Qty
1
8
2
8
Step 2:
Insert four Screws (3) by hand to hold the Lower Shelf (D) to the Legs (B) and Legs (C).
Once these four Screws have been inserted. Tighten all Screw with the Hex Wrench (5).
Turn the table upright.
Item
Drawing
Qty
3
4

Longs Peak Console Table OF-1002
www.DTYStore.com
Page 4 of 4
Post-Assembly Instructions:
Periodically check fasteners to be sure they do not loosen over time.
Do not stand or sit on this item.
Outdoor Furniture Care Instruction:
With the proper care your premium eucalyptus furniture will last up to 25 years or more. For unfinished furniture,
we suggest lightly sanding the surface of the furniture with 150 or 180 grit sandpaper once a year to remove any
fuzziness and any larger splinter causing fibers that occur due to exposure to the elements. Be sure to sand
lightly to retain the natural patina. Furniture with an oil finish should also be treated yearly with a light coat of
wood oil designed for eucalyptus or teak by applying it with a soft cloth. For finished furniture, we recommend
brushing off any loose dirt or debris with a soft brush and wiping down with a mild detergent and water. We
recommend you protect your furniture in the off season by using a using a good quality furniture cover. It helps
keep your furniture clean and protects it from the elements thus minimizing annual maintenance.