Ducati HYPERMOTARD 939 User manual

Owner’s manual ENGLISH
1

This manual forms an integral part of the motorcycle and must be kept with it for its whole service life.
If the motorcycle is resold, the manual must always be handed over to the new owner.
This manual must be preserved with care. If it is lost or becomes damaged, contact a Ducati Dealer or
authorised Service Centre without delay to obtain a new copy of the manual.
The quality standards and safety of Ducati motorcycles are steadily improved as new design solutions,
equipment and accessories are developed. While the information contained in this manual is current at the
time of going to print, Ducati Motor Holding S.p.A. reserves the right to make changes at any time without
notice and without any obligations. For this reason, the illustrations in this manual might differ from your
motorcycle.
Any and all reproduction or spreading of the contents herein in whole or in part is forbidden. All rights reserved
to Ducati Motor Holding S.p.A. Any request for written authorisation shall be addressed to this company,
specifying the reasons for request.
Enjoy your ride!
2

Table of contents
Introduction 7
Safety guidelines 7
Warning symbols used in the manual 8
Intended use 9
Rider's obligations 9
Rider's training 10
Apparel 10
Safety "Best Practices" 12
Refuelling 14
Carrying the maximum load allowed 15
Information about carrying capacity 15
Dangerous products - warnings 16
Vehicle identification number 18
Engine identification number 19
Instrument panel (Dashboard) 20
Instrument panel 20
Acronyms and abbreviations used in the
Manual 25
Technological Dictionary 25
Function buttons 27
Main functions 28
Parameter setting and displaying 29
Vehicle speed indicator 31
Engine rpm indicator (RPM) 32
Gear indication 33
Menu 1 functions 35
Odometer 36
Trip meter 1 37
Trip meter 2 38
Partial fuel reserve counter 39
Average fuel consumption 40
Instantaneous fuel consumption 41
Average speed 42
Trip time 43
Menu 2 functions 44
Engine Coolant temperature 45
Ambient air temperature 47
Clock 48
Set-Up - Riding Mode set indication 49
DTC 50
ABS 55
3

Service indication (SERVICE) 59
Indication if the LAP function is active/not
active 62
Set-Up function (RIDING MODE) (riding mode
change) 63
Error displaying (ERRORS) 66
Setting menu 72
Customising the RIDING MODE 74
DTC set-up 78
ABS set-up 80
ENGINE set-up 82
ALL DEFAULT (restoring the default parameters of all
RIDING MODES) 84
DEFAULT (restoring the default parameters of a
single RIDING MODE) 86
Instrument panel back-lighting setting
(B.LIGHT) 88
Lap Timer (LAP): LAP on/off 90
Lap Timer (LAP): LAP recording 92
Lap Timer (LAP): view of stored LAPs 94
Clock setting function (CLOCK) 98
Battery voltage function (BATTERY) 100
Engine rpm digital indication (RPM) 101
Immobilizer code (PIN CODE) 102
Setting the unit of measurement (UNITS) 110
Other functions 119
Light control 121
Immobilizer system 124
Keys 125
Operation 126
Key duplication 127
PIN CODE entering function for overriding
purposes 128
Controls 131
Position of motorcycle controls 131
Key-operated ignition switch and steering
lock 132
Left-hand switch 133
Clutch lever 134
Right-hand switch 137
Throttle twistgrip 138
Front brake lever 139
Rear brake pedal 140
Gear change pedal 141
Adjusting the position of the gearchange pedal and
rear brake pedal 142
Main components and devices 144
Position on the vehicle 144
4