5
3.2 Initial Setup
3.2.1 Setup the Digital Visualizer
1. Pull up the arm and camera head, then turn the camera head toward the platform and fully
raise it into position.
2. Press and slide the latches (Lamp releases) to release the lamp lock. Then pull up the lamp
arms.
3. Rotate the folded lamp to face the platform as the arrow shows.
※Note:The angle of the camera head, lamp arm, and lamp head is `limited. Do not turn it
forcefully when it reaches the limit.
3.2.2 Power On
※Note:Before using the Digital Presenter, make sure that you have it connected to the
computer, video source, or other output devices. Please refer to the 3-1 section.
1. Press (the『POWER』button) for about 1 second to power on the Digital Presenter. The
red LED (flashing until the presenter is started) turns to green.
2. Press the 『LAMP』button on the remote control to switch the side lamps or backlight.
Note: you can often rotate the camera head for better subject lighting.