DVTECH Solution VP-602HHTU User manual

V
V
VP
P
P-
-
-6
6
60
0
02
2
2H
H
HH
H
HT
T
TU
U
U
0
User Manual
Presentation Switcher
with HDMI and VGA solutions
6x2
VP-602HHTU
V.2015VP-602HHTU.00

V
V
VP
P
P-
-
-6
6
60
0
02
2
2H
H
HH
H
HT
T
TU
U
U
1
COPYRIGHT AND TRADEMARKS
All rights reserved by © DVTECH Solution Corp. No part of this document may be
reproduced in any form or by any means without written permission from the product
manufacturer. Changes are periodically made to the information in this document.
They will be incorporated in subsequent editions. The product manufacturer may make
improvements and / or changes in the product described in this document at any time.
All the registered trademarks referred to this manual are belonging to their respective
companies.

V
V
VP
P
P-
-
-6
6
60
0
02
2
2H
H
HH
H
HT
T
TU
U
U
2
BEFORE YOU BEGIN
Follow all instructions marked on the device during using.
Provide proper ventilation and air circulation and do not use near water.
It is better to keep it in a dry environment.
Place the device on a stable surface (example cart, stand, table, etc.).
The system should be installed indoor only. Install either on a sturdy rack or desk in a
well-ventilated place.
Make sure the rack is level and stable before extending a device from the rack.
Make sure all equipments installed on the rack including power strips and other
electrical connectors are properly grounded.
Only use the power cord supported with the device.
Do not use liquid or aerosol cleaners to clean the device.
Always unplug the power to the device before cleaning.
Unplug the power cord during lightning or after a prolonged period of non-use to avoid
damage to the equipment.
Do not stand on any device while installing the device to the rack.
Do not attempt to maintain the device by yourself, any faults, please contact your
vendor.
Save this manual properly for future reference.

V
V
VP
P
P-
-
-6
6
60
0
02
2
2H
H
HH
H
HT
T
TU
U
U
3
TABLE OF CONTENTS
Copyright and Trademarks..........................................................................................................1
Before You Begin..........................................................................................................................2
Table of Contents..........................................................................................................................3
Chapter 1 Switcher System Overview.......................................................................................5
1.1 Introduction.....................................................................................................................5
1.2 Packing............................................................................................................................6
Chapter 2 Features ......................................................................................................................7
Chapter 3 Specifications..............................................................................................................8
Chapter 4 Device Installation......................................................................................................9
Chapter 5 Front/Rear Panels....................................................................................................10
5.1 Front Panel....................................................................................................................10
5.2 Rear Panel....................................................................................................................12
Chapter 6 Connections..............................................................................................................15
6.1 Input Connections........................................................................................................15
6.2 Output Connections.....................................................................................................16
6.3 Multiple Connections...................................................................................................16
6.4 Remote Control Connection.......................................................................................17
6.5 IR Pass-Through Connection.....................................................................................18
6.5.1 Normal IR Connection......................................................................................18
6.5.2 Extended IR Connection..................................................................................19
6.6 Power Connection........................................................................................................19
6.7 Ports and Switchers.....................................................................................................20
6.7.1 RS-232...............................................................................................................20
6.7.2 HDBaseT Output Port......................................................................................22
6.7.3 Output LED........................................................................................................22
6.7.4 Output Cable.....................................................................................................23
6.7.5 DIP Switcher for 3 Pins....................................................................................24
Chapter 7 Remote Configurations...........................................................................................25
7.1 Telnet Commands........................................................................................................25
7.1.1 Command List and Reboot.............................................................................25
7.1.2 IP/Telnet Configuration ....................................................................................26
7.1.3 Device Configuration........................................................................................28
7.1.4 AV Matrix Protocol Command.........................................................................35
7.2 RS-232 Commands.....................................................................................................36
7.2.1 Commands List and Status.............................................................................37
7.2.2 HDMI Command...............................................................................................38

V
V
VP
P
P-
-
-6
6
60
0
02
2
2H
H
HH
H
HT
T
TU
U
U
4
7.2.3 EDID Command................................................................................................39
7.2.4 Audio Commands.............................................................................................39
7.2.5 Restore Default Command..............................................................................41
Chapter 8 Troubleshooting........................................................................................................42
Appendix A HDBaseT Firmware Upgrade ..............................................................................44
VE-70HHTW-F HDBaseT F/W Upgrade.........................................................................44
Switcher HDBaseT F/W Upgrade....................................................................................46
Appendix B Extender.................................................................................................................49
Features...............................................................................................................................50
Specifications ......................................................................................................................51
IR Receiver Cable Directions............................................................................................52
IR Blaster Cable Directions...............................................................................................52
HDMI Output Connector....................................................................................................52
Wiring Information for Link Connector.............................................................................53
Appendix C Firmware Upgrade................................................................................................54
Matrix....................................................................................................................................54
F/W Upgrade.......................................................................................................................55
General Upgrade........................................................................................................55
Module Upgrade.........................................................................................................56
Manual Upgrade.........................................................................................................58
Network................................................................................................................................60
IPM Upgrade.......................................................................................................................61

V
V
VP
P
P-
-
-6
6
60
0
02
2
2H
H
HH
H
HT
T
TU
U
U
5
CHAPTER 1 SWITCHER SYSTEM OVERVIEW
1.1 Introduction
The Presentation Switcher is a high performance, zero-second latency switching
equipment with 6x2 transmission interfaces. It is a switcher and also a converter means
that it can handle virtually video/audio signals on its 6 inputs including HDMI and VGA.
Split the HDMI signal and mix with the audio signal comes from the MIC1/2 input
interface integrated the optical SPDIF or R/L stereo audio output signal. The built-in
converter handles analog to digital conversion, as well as the signals conversion is
virtually converted to any output equipments including any projector, TV or other audio
amplifier. Built-in extender interfaces allowing you to integrate external extensible
accessory devices to transmit data or to over long distances up to 70 meters.
The Switcher can be controlled in some ways; the front panel offers input/output
selection and audio configured control, as well as an IR receiver connected to rear panel
for user to control the VP-602HHTU with a IR controller. The Switcher provides the utilize
TCP/IP and RS232 rear panel allowing users to control the switcher through a browser
on the PC.
Figure 1-1 VP-602HHTU Switcher

V
V
VP
P
P-
-
-6
6
60
0
02
2
2H
H
HH
H
HT
T
TU
U
U
6
1.2 Packing
VP-602HHTU Switcher *1
Power Cord *1
CD *1

V
V
VP
P
P-
-
-6
6
60
0
02
2
2H
H
HH
H
HT
T
TU
U
U
7
CHAPTER 2 FEATURES
3*HDMI In (Up to 4K*2K@30fps or YCBCR4:2:0 4K*2K@60fps)
3*VGA In + 3*3.5Stereo Audio Inputs Associated with Each VGA Connection
(VGA Support Resolution Shown Below)
VGA Input (Support Video Modes)
60Hz
640*480, 800*600, 1024*768, 1152*864, 1280*600, 1280*720,
1280*768, 1280*800, 1280*960, 1280*1024, 1360*768, 1366*768,
1400*1050, 1440*900, 1600*900, 1600*1200, 1680*1050, 1920*1080
75Hz
640*480, 800*600, 1024*768, 1152*864, 1280*800, 1280*1024
2*Microphone Input (XLR Connector)
MIC inputs can be provided up to +48V phantom power
2*HDMI Output (Different Displays) w/HDBaseT 70 Meters Output (Bypass Input
Audio Only, None Microphone Mixer)
Knob Adjustable for Source Volume, Microphone 1&2 Volume, Main Audio OUT
Volume. (Press Knob Once for Mute)
Microphone “Take-Over”Mode to Mix the Microphone Signal w/ the Source Audio
Independent L/R Output, Coaxial Output, and TOSTLINK SPDIF Output (Source
Audio is from 3.5Stereo Audio or De-embed from HDMI Source)
Support EDID Management
LCD Display for Status Read Easily
8*Front Panel Pushbuttons for Source Selection (Output *2/Input *6)
Supports IR Remote/RS-232/Ethernet Control
HDBaseT Technology, Use One CATx Cable to Install Easily
Internal universal power supply
1U rack Unit Height

V
V
VP
P
P-
-
-6
6
60
0
02
2
2H
H
HH
H
HT
T
TU
U
U
8
CHAPTER 3 SPECIFICATIONS
Hardware
LCD Module
1
Pushbuttons
12
Knob
4
Input Connector
HDMI Type A*3/VGA*3
Output Connector
HDMI Type A*2 /RJ-45*2
IR IN
3.5Phone Jack*2
IR OUT
3.5Phone Jack*2
RS-232
3.5Phone Jack*2
MIC Input
XLR Connector*2
Audio Input
3.5Phone Jack*3
Audio Output
RCA Connector (R,L)*2 sets
Digital Optical Toslink*2
RCA Digital Audio*2
LAN Connector
RJ-45*1
IR Ext.
1
3 pins Dip Switcher
1
Power
100VAC~240VAC, 50/60Hz, internal
Main Power Switch
1
Housing
Aluminum/Metal
Mounting
1U Rack mountable
Weight
3.6 kg
Dimensions (LxWxH)
482*357*45 mm
Control Information
HDMI Cable Distance
10 meters (At least)
Cat.5e Cable Distance
70 Meters (Max.)
Baud Rate
9600 bps, 8 data bits, 1 stop bit, no parity
Ethernet Protocol
HTTP, DHCP, TCP/IP, Telnet
Serial Control Port
RS-232:9 Pin Female D Type Connector
Remote Control
Remote Controller, IR Receiver Cable
Telnet Server
LAN

V
V
VP
P
P-
-
-6
6
60
0
02
2
2H
H
HH
H
HT
T
TU
U
U
9
CHAPTER 4 DEVICE INSTALLATION
The Switcher has a black metallic housing. It can be placed on a sturdy desk directly or
installed on a rack.
Attach the rubber feet to the bottom of Switcher, Place the Switcher on a sturdy, level
surface that can support Switcher’s weight.
Figure 4-1 Place the Switcher on a sturdy surface
Or use the screws provided with the rack and a screw driver to firmly tighten the Switcher
in the rack to prevent working lose due to vibration in the rack.
Figure 4-2 Mount the Switcher in the rack