dynabook Satellite Pro E10-S User manual

Nov 23th, 2021
Dynabook Laptop Components Classified as Requiring Selective Treatment
Dynabook would like to communicate the method of identifying and removing components
contained in Dynabook notebook products, including but not limited to the Dynabook
Satellite Pro E10-S model, that requires selective treatment based on the European
WEEE Directive, Directive 2012/19/EU of the European Parliament and of the Council on
waste electrical and electronic equipment (WEEE).
All of the instructions provided within this letter can be reviewed in greater detail within the
Satellite Pro E10-S Series Maintenance Manual.
Tools Required
In order to remove internal components of the Satellite Pro E10-S some tools from the list
below may be required located in Chapter 4 Replacement Procedures of the Dynabook
Maintenance Manual
Table of Contents
• (Page 2-3) Removing the Lithium Ion Battery (Main Battery)
• (Page 4) Removing the SSD
• (Page 5) LCD, Printed Circuit / Wiring Boards (PCB/ PWB system board)
• (Page 5) Manual Replacement Procedures
• (Page 6) AC Adapter and external provide cables

1. Removing the Lithium Ion Battery (Main Battery)
Please refer to the information below for instructions regarding the identification and removal of the
lithium ion battery. Further maintenance instructions can be found in section 4.2 of the Satellite Pro
E10-S Maintenance Manual. Some tools are required in order to remove this component. Once
removed, these components should be recycled as per local requirements.
To remove the battery, the base assembly must be removed first:

2. Removing the SSD
Please refer to the information below for instructions regarding the identification and removal of the
SSD.
Please refer to the information listed in section 4.4 of the Satellite Pro E10-S SeriesMaintenance
Manual.
One Philips screwdriver with type 1 bit will be required to remove the screws indicated in the locations
below. Once removed, these components should be recycled as per local requirements.

3. Removing the LCD and Printed Circuit / Wiring Boards
Beside the LCD and the main PCB, there are further small PCBs and components which are in the
scope of the WEEE Directive. The removal of those components are described in detail in the
chapter 4 of associate maintenance manual.

AC Adapter, External cables provided with the AC adapter and USB cables
Depending on your purchased model there are different AC adopters or cables supplied. Those parts
should be recycled as per local requirements.