• WALK/RUN MODE: Once the buckles have been correctly adjusted, open the rear lever
to switch the mechanism to walk mode and at the same time release the cuff, and
open the Ultra Lock Strap (if present). This simple action enables you to walk and run
with incredible agility and freedom of movement.
• SKI MODE: Close the Ultra Lock Strap (if present) and then close the rear lever to lock
the boot into ski mode and at the same time tighten the cuff. When the lever is closed
the mechanism will lock into place automatically following the rst ex of the cuff.
TF CUSTOM READY – CUSTOM LIGHT: Always refer to an authorized DYNAFIT retailer
when molding your liners. In order to get the best t and to be covered by the warranty
we recommend using only blowing heat towers shown on the picture (1) and not others
heating systems.
MOLDING LINERS: Remove the footbed (if present) before heating the liner. Warm up
the liners with air blowing heating system. Do all shaping with the liners in the boots, do
not warm up the liners separately from the shells to avoid damaging them. During the
heating time prepare your feet wearing the socks you usually use during the activity, put
the toe caps on your toes in order to gain room on the toe box (2) and the Nylon socks
useful to slip into the boot (3). Just a bit before the count down is nishing, take out
the rst boot and leave the second one on the machine. Place the footbeds (if needed)
back into the boot before stepping in. Place your foot into the boot helping you with a
shoehorn. Close the boot into downhill mode to a level of medium tightness. Remain in a
stable standing position and wait at least 10 minutes to allow the liner to cool down and
walking on the heels in the rst 10 seconds. Repeat these points for the second boot.
External abrasion on Thermoformable liners is normal. In the boot box, special patches
are provided to reinforce your liners if you start to see abrasion occurring on the outside
of the liners.
CARE AND MAINTENANCE OF YOUR DYNAFIT BOOTS:
• Use only mild soap and water to clean your boots.
• If the liners are wet, remove them from the shells. Take out the footbeds and place
them in a warm, dry place. Keep them away from direct heat sources, such as radia-
tors, replaces, or ovens, as this may cause damage or change the t.
• Before storing the boots for an extended period of time, be sure the liners and shells
xare completely dry. Place the liners in the shells and close the buckles loosely.
• With time and sun exposure, the coloration of the boots may change. Especially the
white color could become less bright. To preserve the color of your boots we suggest
that you store them in their box or in a place protected from direct sunlight.
