Dynamic CCTV AXPRO User manual

AXPRO Interconnected Smoke Alarms
You can have up to 12 smoke detectors interconnected with around 30m distance indoors and 100m
in open space. The distance will all depend on the building construction.
Turn on the power for the rst detector as shown below.
Now you will need to short press the coding button on the bottom of the rst detector, The red LED
will then ash slowly on the unit when it does release the button.
Turn on the power for the second detector as shown below.
Short press the coding button on the bottom of the second detector, Again the red LED ashes slowly
once it does release the button.

The two smoke detectors will now be in coding mode and the coding period is around 60 seconds,
when paired successfully both units LEDs will illuminate green and produce an audible alert. If they
do fail to pair, please repeat the process.
To connect additional smoke detectors, repeat the previous steps, First choose the new smoke alarm
you would like to add, then choose a smoke alarm already interconnected. The new smoke alarm will
join the existing network.
Once all smoke alarms are interconnected, press the Test/Hush button on each smoke alarm and en-
sure the sounder operates on all interconnected smoke alarms.
01642 220166 www.dynamic-cctv.com