3.2 Installing the drivers
If you use Windows 2000/XP you do not need to install drivers.
Driver installation Windows 98SE/ME:
Please follow the steps below to install the USB drivers.
1. Insert the provided CD-Rom into your CD-Rom player.
2. Connect your HDCS04 to your computer by either using the S-ATA or the USB
cable.
3. Your computer will now find new hardware and will tell you to install the drivers.
Please click “Next” in the “Found new hardware” wizard.
4. Enable the checkbox next to the option “CD-Rom” and click “Next”.
Windows will now find and install the needed drivers. After installation it might be necessary
to reboot your computer before you can use your HDCS04. (Refer to chapter 5 if you are
experiencing difficulties)
3.3 Preparing your hard disc for usage
You will need to follow these steps only if you are using a new (empty) hard disc.
Windows 98SE / ME:
1. Click “Start” then “Run” then type “command” in the text box.
2. Type “FDISK” and press “ENTER” on your keyboard).
(If asked to enable support for large volumes, please answer “Yes”).
3. Press “Y” then “ENTER” on your keyboard.
4. Select option “5” from the menu then select the hard disc that needs to be partioned.
5. Select option “1” from the menu (“setup a DOS or Logical partition”).
6. Again select option “1” from the menu to create a “primary partition”.
Your computer will now check the integrity of the hard disc, proceed with the steps below after
the check has finished:
1. Select the largest possible partition size.
2. Press “ESC” on your keyboard until FDISK terminates down.
