EarthQuaker Devices Hoof Repeater User manual

OPERATION MANUAL
©2018 EarthQuaker Devices LLC
<<< Power Requirements >>>
<<< Tech Specs >>>
• Current Draw: 18mA
• This device take a standard 9 volt DC power supply with a 2.1mm negative center barrel. We
always recommend pedal-specic, transformer-isolated wall-wart power supplies or multiple
isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power.
Switching-type power supplies, daisy chains and non-pedal specic power supplies do not lter
dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!
Hoof
• Input Impedance: 130K Ohm • Output Impedance: <10K Ohm
Tone Reaper
• Input Impedance: 47K Ohm • Output Impedance: <1K Ohm
Octave
• Input Impedance: 160K Ohm • Output Impedance: <10K Ohm
<<< Warranty >>>
This device has a limited lifetime warranty. If it breaks, we will x it. Should you encounter any
issues, please email [e-mail].
www.earthquakerdevices.com
<<< Flexi-Switching >>>
This device features Flexi-Switch™ Technology! This relay-based, true bypass switching style
allows you to simultaneously use momentary and latching-style switching.
• For standard latching operation, tap the footswitch once to activate the effect and then tap
again to bypass.
• For momentary operation, hold the footswitch down for as long as you’d like to use the effect.
Once you release the switch, the effect will be bypassed.
Since the switching is relay-based, it requires power to pass signal.

<<< Controls >>>
Hoof
Level: Controls the output volume
Fuzz: Controls sustain and gain
Tone: Treble to the right. Bass to the left
Shift: Controls the mid frequencies. More
pronounced to the left. Scooped to the
right.
Tone Reaper
Level: Controls the output volume
Fuzz: Controls the sustain and nature
Tone: Treble to the left. Bass to the right
1
2
3 7
4
5
6
The Hoof Reaper™ features our popular Hoof™and Tone Reaper™ fuzz pedals in one handy
enclosure with the added bonus of an old school analog octave up. It was originally released as
a special limited run item back in 2010 and demand was so high that we decided to reintroduce
it back into our line. Capable of creating everything from subtle octave up overtones through
crushing octave squalls that simulate exploding stacks of amps. Each effect can be used
individually, as well as in series but the order of effects is preset for optimum performance.
Available switching combos:
Hoof Alone
Reaper Alone
Octave Alone
Reaper + Octave
Hoof + Octave
Hoof + Reaper
Hoof + Reaper + Octave
Use the individual switches to activate the level of mayhem you wish to unleash.
Hoof
Our agship device! The Hoof is a no-fuss, easy-to-use device capable of sounds from warm,
gritty overdrive to a huge, sustaining fuzz. It’s a germanium/silicon hybrid Muff-style fuzz
(based on the old green Russian muff) with massive amounts of volume on tap and smooth
amp-like sustain. It has a tighter, cleaner sound than most Muff’s which makes it more cutting
and discernible in a band setting. The shift control is the key to the Hoof’s character, it alters
the frequency response of the tone control. Clockwise scoops the mids and counterclockwise
enh anc e s the mids. The Hoof has bec om e th e go - to fuz z for many wel l-k nown f uz z c onn oi ss eurs.
Tone Reaper
The Tone Reaper is a vintage style fuzz device based on the “3 knob” bender. It’s a silicon/
germanium hybrid capable of producing a wide range of tones from every bender era with
careful tweaking of the Tone and Fuzz controls. From thin and spitty, to thick, growling sustain;
it’s all here.
Octave
This is a classic monophonic octave up that will add a swelling octave to the fuzz tone! Since
it is monophonic, the effect will be more pronounced when using the neck pickup and playing
above the 12th fret. 43 7
1 2 5 6