EAW AC6 User manual

Tel [phone] | www.eaw.com 1
AC6 Stinger Instructions
These instructions are to provide a detailed step by step procedure for using the AC6
Stinger kit.
Inventory your kit
Part # Part Name Quantity Reference
2071927-9999 PLATE LOCKING ASSY 1 A
2071924 M5X20 FLH SKT SS BLK 7 B
2071918-9999 Slide Plate 1 C
2072045-9999 Stinger Mount 2 D
2072041-9999 Stinger 2 E
2071404-9999 Mohawk 1 F
E
D
C
A
B
F

Tel [phone] | www.eaw.com 2
AC6 Stinger Instructions
Prepare AC6 for Stacking
1. Attach Locking Plate (A) to the top of the rst AC6
• Remove 3x M5x12mm screws from top of AC6 (Figure 1).
• Position Locking Plate over open holes, then use 3x screws (B) to secure plate
to the cabinet (Figure 2)
Figure 3 - Remove screws Figure 4 - Install Slide Plate
2. Attach slide plate (C) to bottom of next AC6
• Remove 4x M5x12mm screws from bottom of AC6 (Figure 3).
• Position Slide Plate over open holes, then use 4x screws (B) to secure plate to
the cabinet (Figure 4)
Figure 1 - Remove screws Figure 2 - Install Locking Plate

Tel [phone] | www.eaw.com 3
AC6 Stinger Instructions
Connect two AC6 Column loudspeakers with stacking plates
3. Attach two AC6 columns
• Slowly lay down AC6 with slide plate grill down on a rug or blanket
• Insert next unit with locking plate to connect (Figure 5)
• On rear of rst AC6 locking plate, rotate both screw knobs clockwise to lock
into position.
Figure 5 - Attach AC6 columns Figure 6 - AC6 columns grill down
Attach Stinger to AC6 Array
4. Attach Stinger Mounts (D) to AC6
• Center the mount on the Flytracks for each AC6 (Figure 6)
• Turn the knobs on the mount clockwise to lock into place.
Figure 7 - Position Mount Figure 8 - Stinger Mount attached

Tel [phone] | www.eaw.com 4
AC6 Stinger Instructions
5. Attach Stinger (E) to Mounts
• Place stingers in place on the mounts (Figure 9)
• Use supplied pins to secure the two stingers together
• Using pins on mount, secure stinger assembly to mount plates (Figure 10)
Figure 9 - Position Stingers on mounts Figure 10 - Pin stinger assembly to
mount plate
Figure 11 - Stingers assembled with AC6 array
6. Attach Mohawk (F) and suspend/y array
• Attach Mohawk with pins at the end of the stinger (Figure 12)
• Once all pins and knobs are veried as secure, suspend array using a shackle.
Figure 12 - Attach Mohawk to Stinger
Figure 13 - Mohawk installed on Stinger Figure 14 - Completed Stinger Array