EAW Subwoofer DCT2 User manual

SPECIFICATIONS DCT2
FEATURES
DESCRIPTION
APPLICATION
PERFORMANCE
PHYSICAL
One Main Street, Whitinsville, MA 01588 508 234 6158 Toll Free 800 992 5013 FAX [phone] [e-mail] www.eaw.com
EAW products are continually improved. All specifications are therefore subject to change without notice. DCT2/2 pp October 2001 Printed in USA
Frequency Response ±3 dB 5 kHz to 15 kHz
-10 dB 4.5 kHz
Axial Sensitivity (dB SPL, 1 watt @ 1 m)
HF 110
Nominal Input Impedance (ohms)
HF 32
Power Handling (watts, continuous)
HF 75
Recommended High-Pass Frequency
24 dB/octave 5 kHz
Calculated Output Limit (dB SPL @ 1 m)
HF Peak 134
HF Long Term 128
Nominal Beamwidth (degrees @ -6 dB SPL)
Horizontal 120
Vertical 100
Product Group Avalon
Configuration Dedicated VHF
VHF Subsystem 3x 1.33-in compression tweeters,
horn loaded
Enclosure Material Exterior-grade Baltic birch plywood
Finish Wear-resistant textured black paint
Connectors 2x Neutrik NL4 Speakon
Suspension Hardware 4x 1/4”-20 threaded mounting
points (4 top) for Omnimount
Series 100-type bracket
Dimensions inches millimeters
Height 5.3 133
Width 13.5 343
Depth 6.8 173
Baffle Angle 40°
Weights pounds kilograms
Net Weight 17 7.5
Shipping Weight 23 10.2
•Dedicated supertweeter array
•Three high frequency compression tweeters
•120°(H) dispersion from wall- or loudspeaker-mounted
location
The DCT2 is engineered for use in permanent installations. The
system mounts three horn-loaded 1.33-in exit compression
tweeters in a wide-angled enclosure. The driver/phase plug
assemblies are engineered to minimize beaming of sound-
waves with the smallest wavelengths, particularly in the hori-
zontal plane.
The DCT2's wide-angled configuration delivers optimized 120°
horizontal dispersion of high frequencies when mounted adja-
cent to or on a full-range system. It provides very high lev els
of high frequency sound reinforcement for high energy dance
clubs.
Like all EAW products, it can be special ordered in virtually any
color to match a specific décor. Six year warranty.

SPECIFICATIONS DCT2
DIMENSIONAL DRAWING INPUT PANEL
One Main Street, Whitinsville, MA 01588 508 234 6158 Toll Free 800 992 5013 FAX [phone] [e-mail] www.eaw.com
EAW products are continually improved. All specifications are therefore subject to change without notice. DCT2/2 pp October 2001 Printed in USA
510943 (A)
7/31/01
Manufacturing tolerances are +/- 0.13 and +/- 1°
INDICATES MOUNTING POINT,
1/4-20 THREADED HOLE (T-NUT).
INDICATES CENTER OF BALANCE.
L
1.75
6.25
2.75
2.00
C
TOP
5.17
4.25
6.75
40¡
C
L
BACK
2.75 4.00
INPUT
L
C
3.00
FRONT
13.50
5.25
BOTTOM
(2.75)
RIGHT SIDE
PIN 1--...--
PIN 1+...+
WHITINSVILLE, MA USA
S/N
DCT2
NL4 MPNL4 MP NL4 MPNL4 MP