EchoStar Hughes 4200 User manual

1. Unpack the box. Remove the accessories panel on top, then without tearing the
plastic over the UT, lift it out of the box, unfold the flaps, and slide it out of the
sleeve.
2. Insert the SIM card supplied by your service provider.
3. Install the battery and completely charge it with the AC/DC adapter before using
the terminal.
4. Power on the UT by long pressing the Power button (>2 seconds).
5. Connect an Ethernet cable from your computer to the UT. Open a web browser and
enter the address 192.168.128.100 to access the home page of the UT Web User
Interface.
Note: you can connect via Wi-Fi instead of Ethernet. Long press (>2 seconds) the
Wi-Fi button on the UT. Once the icon shows solid on the LCD, you can
connect to the UT. (It is strongly suggested to establish a secure password through
the Settings Page of the UT Web User Interface).
6. You now need to define an APN Profile in order to be connected to the Network.
Enter the APN details (at least Profile Label and Profile APN) in the Settings Page.
Press the “Add Profile” button in order to save the Profile.
Hughes 4200 Quick Start Guide
3004181-0001 Rev.B
Button function, long press (>2 sec)
Button function, short press (<2 sec)

7. In the Default APN Profile settings select the APN Profile you just added.
Press the “Apply Changes” button in order to update the Default APN.
A pop-up will appear to confirm the Default APN update.
8. Set up the UT in an open area and allow it to acquire a GPS fix. The GPS satellite
icons on the display will indicate when the UT can see the GPS satellites. The GPS
icon will go solid, and the satellite icons will disappear when the UT has a fix.
Note: It is recommended to lay the terminal horizontal to get a fix as quickly as
possible.
3004181-0001 Rev.B
Regulatory and safety information is provided in the user manual which can be downloaded from the website http://echostarmobile.com
Des renseignements sur la réglementation et la sécurité sont fournis dans le manuel d’utilisation qui peut être téléchargé à partir du site Web http://echostarmobile.com
9. Point the UT at the satellite using the pointing information on the LCD.
10. Optimise the signal shown on the LCD by adjusting the direction and elevation angle of
the unit. You can also press the audio button to get an audible indication of the signal.
11. You now have a “Shared” connection with Internet access.
To satellite