ECOPERLA PROFINE POU 3 User manual

ULTRAFILTRATION
SYSTEM
ECOPERLA
PROFINE POU 3
ORIGINAL PRODUCT OF ECOPERLA
USER MANUAL

2
Product description
This product is designed for filtration of drinking water. The kit includes a ball valve with an adapter to
connect the device into the water system, a support frame, a flexible hose, two quick disconnects, a faucet
with mounting accessories and three cartridges.
BEWARE: THE DEVICE REQUIRES REGULAR MAINTENANCE TO GUARANTEE THE REQUIREMENTS
FOR TREATED DRINKING WATER AND MAINTENANCE AS DECLARED BY THE MANUFACTURER.
System functions
The Ecoperla Profine POU 3 filter contains a mechanical 5-micron pre-filter cartridge and it removes
unwanted odours, aromas and chemical compounds that may be found in drinking water. The ultrafiltration
membrane stops suspended solids and colloids above 0.1 micron, preventing 99.99% of bacterial and viral
penetration.
Declaration of conformity
The system is compliant with Ministerial Order 25/2012 and Ministerial Order 174/04.
Intended use
According to Ministerial Order 25/2012, the device is intended for treatment of DRINKING WATER under
the conditions and in accordance with the provisions of Executive Order 31/2001. It is strictly forbidden to
use the system for treatment of non-drinking water or water of uncertain origin or, in any case, water with
microbiological contamination.
Use only original replacement cartridges to ensure correct operation under the conditions specified by the
manufacturer.
DISPOSAL OF USED CARTRIDGES IN ACCORDANCE WITH DECISION 2014/955 / EU (EWC 15 02 03).
ANY MISUSE RESULTS IN IMMEDIATE LOSS OF WARRANTY AND NO LIABILITY ON THE PART OF THE
MANUFACTURER.

3
Ecoperla Profine POU 3 | user manual
Ecoperla Profine
POU 3
1 piece
faucet
1 pieces
faucet
accessories
1 piece
ball valve and
adapter 3/8”
1 piece
hose 3/8"
3 metres
quick disconnect 3/8
2 pieces

4
Ecoperla Profine POU 3 | user manual
IN OUT
Cold water

5
installation
During installation, the cold water
inlet valve should be closed
During installation, leave the tap
open, close it when you complete
the assembly.

6
Ecoperla Profine POU 3 | user manual
Make sure there is a seal inside the adaptor.
Screw adapter to the cold water inlet valve.
1
2
installation

7installation
3
4
Screw the ball valve into the adapter.
Place the filter upright or screw it to the wall.
Wrap
teflon
Fixing nut

8
installation
Drill a hole in the sink
Faucet installation diagram
5
ø 12 mm
Ecoperla Profine POU 3 | user manual
6

9
8
Connect the hose to the filter in the direction of water flow.
installation
Cut the hose off
perpendicularly
Do not break
the hose
7
Screw the disconnect into the faucet spindle and connect the hose.

10
filtering cartridge
replacement
Open the faucet valve and close the water intake valve.
1
Replace all filtering cartridges at the same time. Before replacing the
cartridges, close the water inlet valve and turn off the tap. The valve
can be opened again the tap can be turned off only after completing
the service. After replacing the cartridges, let the water run at full
flow for at least 5 minutes before drinking.
Unscrew old cartridges Screw in new
2

11
AUTHORISED DEALER/SERVICE PROVIDER
warranty
The dealer guarantees that the Ecoperla Profine POU 3 system will work properly for two
years from the date of purchase. The warranty covers repair or replacement of faulty parts by
the dealer or an authorised service centre.
The warranty does not cover consumables, damage caused by improper use, or mechanical
damage.
The warranty is valid only if all the technical requirements of the water system and the
requirements of the device use are met.
The seller is not liable for any inconvenience caused by incorrect connection and
commissioning of Ecoperla Profine POU 3.
In order to execute the warranty, you need to present proof of purchase. If there is any
problem with Ecoperla Profine POU 3, please contact your dealer.
SERIAL NUMBER:

made in italy by
Thinkwater srl for
Ecoperla
ecoperla.com