ECOSURE RAISED BEDS User manual

INSTALLATION GUIDE
RAISED BEDS
ASSEMBLY GUIDE
Ecosure
Etills Ltd
Unit 1
Whiting Way
Melbourn
Hertfordshire
SG8 6NA
Phone: [phone]
Fax: [phone]
Email: [email protected]
Website: www.ecosure.co.uk

THANK YOU
Thank you for buying an Ecosure Raised Bed. We hope you will be completely
satised with your purchase. This industrial strength product is UK designed
and manufactured – and made to last. If you have any technical enquiries,
please call 01763 261781 option 3.
ASSEMBLY GUIDE
a. Position two sides on their longest,
narrowest side. Position one of the angle
brackets so the xing holes line up.
b. Push the domed bolts through then
x in place using the washers and nuts
provided.
c. Repeat this process for the remaining
bolts. Ensure that all xings are secure.
Tighten using a 13mm spanner.
Weed suppressant membrane can
be laid inside the bed at this stage if
required, lapping up the sides of the
bed.
Fill with soil – and you’re ready to start
growing
TOOLS REQUIRED
13mm spanner 13mm bolts,
nuts & washers
( supplied )
IMPORTANT SAFETY INFORMATION
• While every effort has been made to ensure the safety of our products,
sharp edges may still remain.
• When using any power tools, be aware of others around you and wear
suitable PPE (e.g. eye protectors and gloves).
TIP
Check that the bed is square. Use a tape measure to ensure that
the measurement from corner to corner on both sides is the same.
PREPARATION
• Prepare the ground before setting up the raised bed. Ecosure Raised
Beds should be sited on a at, level base. Rake the area over and check
that it is level using spirit level.
• If required, lay weed suppressant membrane.