Edelbrock 8029 User manual

Catalog # 8029
Brochure # 63-0284
©2004 Edelbrock Corporation
Rev. 6/04 - RS/mc
Throttle Cable Bracket for
GM LS1 Carbureted Applications
Catalog # 8029
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before installing your new throttle cable bracket. If you have any questions or
problems, do not hesitate to contact ourTechnical Hotline at: 1-800-416-8628,from 7am-5pm PST, Monday-Friday, or via
e-mailat: [email protected]. Please fill out and mail your warranty card. Remember to include the model number
of this product in the “Part #____” space. Thank you.
•DESCRIPTION: The GM LS1 throttle bracket allows the use of early type throttle, kickdown, and cruise control cables
when retrofitting a late model LS1 engine into an earlier chassis, when using a carburetor in place of the factory LS1 fuel
injection system. This throttle bracket is included in our Performer RPM LS1 carbureted intake manifold, #7118.
KIT CONTENTS
QTY. Description
2Cable Bracket (Large Opening)
2Cable Bracket (Small Opening)
1GEN III Throttle Bracket Base
46mm x 1.0 x 12mm Serrated Flange Hex Bolt
46mm x 1.0 Serrated Flange Hex Nut
•INSTALLATION NOTES:
1. Attach the GEN III Throttle Bracket Base using the two rear driver’s side manifold bolts.
2. Select the appropriate cable brackets for your application (large or small opening brackets) and attach them to the
GEN III throttle bracket base with the appropriate number of 6mm x 1.0 x 12mm serrated flange hex bolts. (Note: In
our retrofit of the LS1 into a 1974 Camaro, using a TH400R automatic transmission, we only needed one of the small
opening cable brackets for the throttle cable, since a kickdown cable is not used. SeeFigure 1 for example.)
Edelbrock Corporation
2700 California St. • Torrance, CA 90503
Tech Line: [phone] • Office: [phone]
Fax: [phone] • E-Mail: [email protected]
Figure 1 - Throttle Cable Bracket