EDIFIER S2000MK III User manual

Powered Bookshelf Speakers
User manual | Manuel d’utilisateur | Manual de usuario |Bedienungsanleitung | Manuale dell’utente |Manual do utilizador
S2000MKⅢ

1
English
Important safety instruction
Excessively loud music may lead to hearing loss.Please keep the volume in a safe range.
Correct Disposal of this product. This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return your used device,please use the return and
collection systems or contact the retailer where the product was purchased. They can take this product for environmental
safe recycling.
Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus.When a cart
is used,use caution when moving the cart/apparatus combination to avoid injury from tip-over.
1. Please read the instructions carefully. Keep it in safe place for future reference.
2. Use only accessories approved by the manufacturer.
3. Install the instrument properly by following the instructions in the device connection section.
4. Using the product in a 0-35℃environment is recommended.
5. To reduce the risk offire and electric shock, do not expose the product to rain or moisture.
6. Do not use this product near water. Do not immerge the product into any liquid or have it exposed to dripping or splashing.
7. Do not install or use this product near any heat source (e.g. radiator, heater, stove,or other devices that generate heat).
8. Do not place any object filled with liquids, such as vases on the product;neither should any open fire,such as lighted candles
be placed on the product.
9. Do not block any ventilation openings. Do not insert any object into ventilation openings or slots. It may cause fire or electric
shock.
10. Keep sufficient clearance around the product to maintain good ventilation (minimum 5cm is recommended).
11. Do not force a plug into the jack. Before connection,check for blockage in the jack and whether the plug matches the jack
and is oriented to the right direction.
12. Keep the provided accessories and parts (such as screws) away from children to prevent from being swallowed by mistake.
13. Do not open or remove the housing yourself. It may expose you to dangerous voltage or other hazardous risks. Regardless
the cause ofdamage (such as damaged wire or plug, exposure to liquid splash or foreign object falling in,exposure to rain
or moisture,product not working or being dropped, etc.), the repair has to be performed by an authorized service
professional immediately.
14. Before cleaning the product with dry cloth, always turn offthe product and disconnect the power plug first.
15. Never use strong acid, alkali, gasoline, alcohol,or other chemical solvents to clean the product surface. Use only neutral
solvent or clear water for cleaning.

2
English
Important safety instruction
This symbol is to alert the user to the presence ofun-insulated dangerous voltage within the product's enclosure that may
be of sufficient magnitude to constitute a risk of electric shock to persons.
This symbol is to warn the user not to disassemble the enclosure ofthe product and there is no user-replaceable part
inside. Take the product to an authorized service center for repair.
This symbol indicates that the product is for indoor use only.
This symbol indicates that the product is a CLASS II or double insulated electrical device with no earth requirement.
Power warning:
1. Place the product near the power outlet for easy use.
2. Before use, make sure that the operating voltage is the same as your local power supply.Correct operating voltage can be
found on the product plate.
3. For safety purpose, unplug the product during lightning storms or when unused for extended periods of time.
4. Under normal conditions,the power supply may get hot. Please keep good ventilation in the area and exercise caution.
5. Safety warning labels on the housing or bottom of the product or power adaptor.
For wireless product:
1. Wireless product may generate shortwave radio frequencies and interfere with the normal use of other electronic devices or
medical equipment.
2. Turn off the product when it’s disallowed.Do not use the product in medical facilities, on airplane,at gas stations, near
automatic gates, automatic fire alarm system or other automated devices.
3. Do not use the product in the vicinity of a pacemaker within a 20cm range. The radio waves may affect the normal operation
of the pacemaker or other medical devices.
The MAINS plug is used as the disconnect device,the disconnect device shall remain readily operable.

Box Contents
3
English
Remote control User manual
3.5mm - RCA audio cable
RCA - RCA audio cable
Fiber optic audio cable
Speaker connecting cable
Note: Picture for reference only, actual product prevails.

4
English
Illustration
1. Volume dial/Input selection
Press to switch amongst Line in 1→Line in 2→Optical→
Coaxial→Bluetooth input
Press and hold to disconnect Bluetooth in Bluetooth input
2. Treble control
3. Bass control
4. Power switch
5. Power cable
⑦
⑥
⑧
⑨
⑩ ⑪
②
①
③
④
⑤
6. Line in input
7. Optical input
8. Coaxial input
9. Connect to passive speaker
10.Connect to active speaker
11.Display screen

5
English
Remote Control
Four modes:
MONITOR mode: features a flat audio response curve, for sound with no
coloration.
DYNAMIC mode:more punch, more dynamics.
CLASSIC mode:reproduces a classic HIFIsound.
VOCAL mode: human voice emphasized,singer’s position will seem closer
to listener.
1. Power on/off
2. Mute
3. Remote control indicator
4. Line In input
5. Bluetooth input
Press and hold to disconnect Bluetooth
6. Previous track/next track (Bluetooth input)
7. Volume up/down
8. Pause/play (Bluetooth input)
9. Optical input
10. Coaxial input
11. Monitor mode
12. Dynamic mode
13. Classic mode
14. Vocal mode
Point the remote control to the remote receiving window on the speaker,the optimum operational distance is 7 meters.
Displayed value in the display window will alert or blink when the system receives remote control command.
③
②
①
④
⑦
⑤
⑥
⑧
⑩⑨
11 12
13 14
MONITOR
LINE1/2
OPT COAX

6
English
Remote Control
Note:
1. Do not place the remote control in places that are hot and humid.
2. Do not charge the batteries.
3. Remove the batteries when unused for a long period of time to avoid
batteriesleakage.
4. The batteriesshould not be exposed to excessive heat such as direct
sun, fire or similar.
5. Danger ofexplosion if batteriesare incorrectly replaced. Replace only
with the same or equivalent type.
1. As the illustration shows,press remote control batteriescover downward
with thumb and follow the arrow direction to remove cover,uses two
AAA batteries (note the “+” and “-” pole).
2. The batterieslife are normally about 6months; please replace them when
the remote control is not sensitive or the control distance is shortened.
3. Never use old and new batteries together.

7
English
Connectivity Illustration
1. As the illustration shows, connect speakers using speaker connecting cable.
2. Connect speakers to power source using power cable and turn power switch on, the speakers should be ready to go.
Blu-ray player, Game console,Set Top Box

8
English
Line In Input
1. Connect audio source (mobile phone,tablet, etc.) to Line In 1/Line In 2 input port (note color matching) on the rear panel
of the active speaker using audio cable.
2. Press the “LINE 1/2” button on the remote control,or press the “Volume dial/Input selection” dial on the rear panel ofthe
active speaker,display screen will show “LINE 1” or “LINE 2”.
3. Play music on the connected device and adjust the settings to a desired level.
MONITOR
LINE1/2
OPT COAX
or
MONITOR
LINE1/2
OPT COAX

9
English
Optical / Coaxial Input
1. Connect audio source (Blu-ray player, Set Top Box,etc.) to OPT/COAX input port on the rear panel of the active speaker
using fiber optic audio cable or coaxial audio cable (not included).
2. Press the “OPT” / “COAX” button on the remote control, or press the “Volume dial/Input selection” dial on the rear panel
ofthe active speaker,display screen will show “OPTICAL” or “COAXIAL”.
3. Play music on the connected device and adjust the settings to a desired level.
Note:
Only the standard PCM audio signals (44.1KHz/48KHz/96KHz/192KHz) function in optical/coaxial mode.
MONITOR
LINE1/2
OPT COAX
or
MONITOR
LINE1/2
OPT COAX

10
English
Bluetooth Input
1. Press the “ ” button on the remote control, or press the “Volume dial/Input selection” dial on the rear panel of the
active speaker,display screen will show “ ” .
2. Set your Bluetooth device (mobile phone, tablet,etc.) to search and connect to “EDIFIERS2000MKⅢ”.
MONITOR
LINE1/2
OPT COAX
or
MONITOR
LINE1/2
OPT COAX
Note:
Bluetooth connectivity and compatibility may differ amongst different source devices,depending on the software versions of
source devices.

11
English
Power output: R/L (Treble): 15W+15W
R/L (Mid-range and bass): 50W+50W
Frequency response: 45Hz-40KHz
Input sensitivity: Line In 1: 600±50mV
Line In 2: 800±50mV
OPT/COAX: 350±50mFFs
Bluetooth: 450±50mFFs
Audio input: Line In 1/Line In 2/Optical/Coaxial/Bluetooth
Specifications
Declaration for EU
Frequency Band: 2.402GHz ~ 2.480GHz
RF Power output: ≤20 dBm (EIRP)
There is no restriction of use.
The Bluetooth
®
word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by EDIFIER is under license.
Other trademarks and trade names are those of their respective owners.
Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries.
aptX is a trademark of Qualcomm Technologies International, Ltd., registered in the United States and other countries.

12
English
Troubleshooting
No sound
• Check if the speaker is ON.
•Try to turn up the volume using either the master volume control or remote control.
• Ensure the audio cables are firmly connected and the input isset correctly on the speakers.
• Check if there is a signal output from the audio source.
Cannot connect via Bluetooth
• Make sure the speaker is switched to Bluetooth input. If it is in other audio input modes, Bluetooth will not connect.
Disconnect from any Bluetooth device by pressing and holding the “ ”button, then try again.
• Effective Bluetooth transmission range is 10 meters; please ensure that operation is within the range.
• Try another Bluetooth device for connection.
The S2000MK does not turn on
• Check if main power is connected, or if the wall outlet is switched on.
Noise coming from speakers
•EDIFIER speakers generate little noise, while the background noise of some audio devices are too high.Please unplug audio
cables and turn the volume up,if no sound can be heard at 1meter away from the speaker, then there is no problem with
this product.
To learn more about EDIFIER, please visit www.edifier.com
For Edifier warranty queries, please visit the relevant country page on www.edifier.com and review the section titled Warranty
Terms.
USA and Canada:[e-mail]
South America: Please visit www.edifier.com (English) or www.edifierla.com (Spanish/Portuguese) for local contact information.