EDS PowerAll PS13V610-8O-D User manual

PS13V610-8O-D
POWER SUPPLY
8 Outputs 13,6V DC Power Supply
Installation Manual
www.edselectronic.com

1
1
PowerAll is designed and manufactured by EDS to perform
efciently in a wide range of applications such as CCTV, Access
Control and Intrusion alarm systems. It is compatible with all
EDS and 3rd party systems.
2
1

2
3
Model PS13V610-80-D
Environmental class II indoor
Topology Flyback
Electrical
AC input 187V AC-253V AC
Input frequency 50Hz
DC output 13,4V DC - 13,8V DC
Current output 11,5A -12,5A
Output 8 outputs each has 3A fuse protection
(Max total current 12,5A)
DC output fuse type 3A
Maximum power 160W
LED
indicators
Power Green
Fault Yellow
(Low battery)
Contact output Low battery, no voltage, cover open/close
Battery type 12V / 7Ah
Battery slot Available

3
4
General
Housing Metalic
Color Grey
Dimensions (HxWxD) 408x318x122 mm
Weight 5350g
Operating Temperature -10°C / +50°C
Output Card
10 119 1 3 5 72 4 6 8
P1
PO

4
Figure 1: Output card
Output 1 /13.6V - 1A
Output 2 /13.6V - 1A
Output 3 /13.6V - 1A
Output 4 /13.6V - 1A
Output 5 /13.6V - 1A
Output 6 /13.6V - 1A
Output 7 /13.6V - 1A
Output 8 /13.6V - 1A
Relay Output 0.6A - 125V AC / 2A 30V DC
Relay Output 0.6A - 125V AC / 2A 30V DC
Cover switch contact 3A - 125/250V AC
1
7
4
10
2
8
5
11
3
9
6

5
Figure 2: Inside view
Box Connection
The card and fuse terminal are available in the box as shown in Figure 2.
2 3 4
5
1
Output card
Fused terminal block
Cable entery
Cable holder
Battery place
1
3
2
4
5
Figure 3: Fused terminal block
connection
Fused terminal block
connection
Fused terminal block connection
is below, please ensure proper
wiring to the terminals.
Phase
Ground
Neutral
1
321
2
3

6
6WARNING
Ensure that the connected network is grounded.
Be careful when making the connections.
Do not connect wiring when power is on. Ensure power off and wait for 1
minute to wire.
Do not reverse charge and short circuit.
If there is a problem, disconnect the power and contact the service.
If the outer flexible cable or cord of this transformer (SMPS) is damaged,
it must be replaced by the manufacturer or service or similar qualied
person to avoid danger.
This power supply is suitable for indoor use only.
The output of transformer (SMPS) must be selected accordingly as the
voltage can be seen in the specied supply.
Electrical function of transformer
Symbol Explanation
SMPS with safe isolation transformer which is safe
against malfunction
Indoor use only
SMPS (Switching mode power supply unit)

V1. 18.04.2019
Scan this code with your
smartphone to visit
www.edselectronic.com
EDS Elektronik Destek San. Ve Tic. Ltd. Şti.
Meclis Mah. Teraziler Cad. Hayran Sok. No:4 34785
Sancaktepe / İstanbul / Türkiye [phone]
[email protected] / www.edselectronic.com