EINHELL WorkZone WZAW 150 User manual

GB IRE WZAW 1500151 649 1500 1890 946 244 www.einhell.co.ukAFTER SALES SUPPORT
arC WEldEr
Quick Set-Up Guide
using tHE arC WEldEr
IMPORTANT: Read all the safety warnings in the User Instructions before you start welding.
Ensure you wear/use all the appropriate Gloves, Apron and Personal Protective Safety
equipment while you are using the welder.
Easy stEps to gEtting startEd
1) Unpack the Arc Welder
a) Open the carton carefully and
remove all items.
b) Ensure you have all items before
you discard the packaging.
Continued overleaf...
7
1
86
4
3
5
2
9
Fig 1
2) Assemble the Face Shield
Fig 2 K L M
N
O
P
Q
S R
Fig 3 M
K L
Fig 4
Q Q
SFig 5
K, L, M
N
N
Q
Fig 6 S
4.
1.
3.
2. Fig 7 Fig 8
P
P
P
Fig 9
O
P
O
R

GB IRE WZAW 1500151 649 1500 1890 946 244 www.einhell.co.ukAFTER SALES SUPPORT
5) Refer to the User Instructions for all other information.
IMPORTANT: Keep the electrode away from any item connected to the earth
terminal, when you switch on the welder.
4)
Easy stEps to gEtting startEd - ContinuEd
• Place the welding glass (l) and the transparent safety glass (m) over it in the frame for
the safety glass (k) (Fig. 3).
• Press the safety glass retaining pins (q) into the holes in face shield frame (s) from the
outside (Fig. 4).
• Place the frame for the safety glass (k) with the welding glass (l) and transparent safety
glass (m) from the inside into the recess in the face shield frame (s), press the safety
glass retaining bushes (n) onto the safety glass retaining pins (q) until they engage to
secure the frame for the safety glass (k). The transparent safety glass (m) must be on
the outside (Fig. 5).
• Bend the top of the face shield frame (s) inwards (Fig. 6/1) and fold down the top
corners (Fig. 6/2).
Now bend the outer sides of the face shield frame (s) inwards (Fig. 6/3) and connect
them by pressing the top corners and outer sides together. When the retaining pins
engage, you should be able to hear 2 clear clicks on each side (Fig. 6/4).
• When the top corners of the face shield are connected as shown in Figure 7, place the
screws for the handle (p) from the outside through the three holes in the face shield
(Fig. 8).
• Turn over the face shield and place the handle (r) over the threads on the three screws
for the handle (p). Secure the handle (r) to the face shield using the three nuts for the
handle (o) (Fig. 9).
3) Connecting the earth Terminal
Connect the earth terminal (-) (2) directly to the part you wish to weld & Insert the
unsheathed end of the selected electrode into the electrode holder & adjust the
current setting on the welder to suit the welding electrode and materials to be
welded. The face shield must be used at all times for welding. It protects your
eyes from the radiation emitted by the arc whilst still enabling you to view the
welding process.
arC WEldEr
Quick Set-Up Guide