Elan EL-SC-ZW User manual

EL-SC-ZW USB Z-Wave Radio/ Antenna
User Guide
The ELAN EL-SC-ZW Z-Wave Radio/ Antenna is an accessory for the ELAN SC series System Controllers.
Connect the EL-SC-ZW to a USB port of an an ELAN SC series system controller.
For Z-Wave configuration, see the EL-SC-ZW Integration Note. Iii;]
Operating Temp: -32 to 122 F (0 to 50 C)
Maximum Operating Voltage (USB VBUS supply): 6V
Typical current consumption: 50 mA
Dimensions: 1.57 X 1.57 X 0.59in (39.99 X 39.99 X 14.64 mm)
Z-Wave Developer's Kit: 7.11.0
Z-Wave Operating Frequency
Australia/New Zealand: 921.42/921.40/919.B0MHz
US/Canada: 908.42/908.40/916MHz
European: 868.42/868.40/869.85MHz
When connected to an ELAN SC Series System Controller, the host application controls the device reset feature
This device may be used with all devices certified with Z-Wave Plus certificate and should be compatible with such devices
produced by other manufacturers.
Regulatory Compliance & Safety Information FCC ID: EF400166 IC ID: 1078A-00166
USA & Canada Compliance FCC Part 15, Subpart B Unintentional Emissions Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Partie 15, sous-section B Unintentional Declaration sur!es interferences des emissions Cet equipementa ete teste etjuge
contorme auxlimites etab/ies pour un dispositifnumerique de c/asse B, conformement a la Partis 15 des reglements de la FCC.
Ces limites sont com;;ues pour fournir une protection raisonnable contre Jes interferences nuisibles lorsque requipement est utilise
dans une installation residentielle. Cet equipementgenere, utilise et peut emettre de l'energie rayonnent trequence et, s'il n'estpas
instal/e et utilise conformement auxinstructions, ii peut causerdes interferences nuisibles aux communications radio.
Cependant, iin'existe aucune garantie que des interferences ne se produirontpas dans une installation particu/iere.

REGULATORY COMPLIANCE & SAFETY INFORMATION
Si cet equipement provoque des interferences nuisibles a la reception radio ou television, ce qui peut l!tre determine
en mettant l'equipement hors et sous tension, l'utilisateur estencourage aessayerde corriger /'interference par une
au plusieurs des mesures suivantes:
• Reorienter au dfJplacer l'antenne de reception.
• Augmenter la distance entre l'equipement et le recepteur.
• Connecter l'Squipement a une prise sur un circuit different de celui sur lequel le recepteurest branche.
• Consulter
le revendeur au un technicien radio I tBIBvision qualifi8 pour obtenir de /'aide.
This device complies with part 15 ofthe FCC rules and Industry Canada's licence-exempt RSSs. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Le present appareil est conforme aux CNR d'lndustrie Canada applicables auxappareils radio exempts de licence. L'exploitation
est autorisee auxdeux conditions suivantes:
(1) /'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouil/age radioelectrique subi, ml!me sile brouil/age est susceptible d'en compromettre le fonctionnement.
IMPORTANT!
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate this equipment.
IMPORTANT!
Taus Jes changements au modifications pas expressBment approuves par la partie responsable de la conformite antpu
vider l'autortte
de f'utilisateur pouractionner cet 8quipement
_,.._~ NORTEK™
SECURITY & CONTROL
www.nortekcontrol.com
All rights reserved. ©2020 Nortek Security & Control LLC.
5919 Sea Otter Place, Suite 100, Carlsbad, CA 92010, USA
P/N: 10026608 (Rev-C)