ELARABY Tornado THB-600M User manual

THB-600MTHB-600M
يوﺪﻳ طﻼﺧ
ﻞﻴﻐﺸﺘﻟا ﻞﻴﻟد
ﻰﺑﺮﻌﻟا ﺔﻛﺮﺸﺑ ﺔﺻﺎﺧ ﺔﻠﺠﺴﻣ ﺔﻳرﺎﺠﺗ ﺔﻣﻼﻋ ﻰﻫ وﺪﻴﻧرﻮﺗ ﺔﻣﻼﻌﻟا هﺬﻫ
ﻞﻳدﻮﻣ
وﺪﻴﻧرﻮﺗ -يوﺪﻳ طﻼﺧ كرﺎﻴﺘﺧ ﺮﻜﺷ









7
ENVIRONMENT FRIENDLY DISPOSAL
You can help protect the environment!
Please remember to respect the local regulations:
hand in the non-working electrical equipments to an
appropriate waste disposal center.
Instruction for egg white beater
CLEANING AND MAINTENANCE
Max operation duration per time cannot exceed 1 minute, and 3 minutes rest time must be maintained at
two consecutive cycles.
1. To assemble the egg white beater with the motor unit, turn the whisk anti-clockwise direction until
tightened. To disassemble, just turn in the adverse direction.
2. Simply plug the hand-held blender to power outlet.
3. Place egg white into the cup, generally, two eggs white is enough.
4. Lower the hand-held blender into food. Then press and hold the low speed button or high speed button
to start operating.
5. To stop the hand-held blender by releasing the low speed button or high speed button of the motor unit.
1. Unplug the appliance and remove the detachable stem.
Note: Do not immerse the detachable stem of the blender in water because overtime the lubrication on the
bearings may wash away.
2. Wash the detachable stem under running water, without the use of abrasive cleaner or detergents. After
nishing cleaning the detachable stem, place it upright so that any water which may have got in, can drain
out. The stem is dishwasher safe component.
3. Wash the cup, bowl, beater and blade in warm soapy water. The bowl and the beater are not
recommended to place in dishwasher as the plastic component deteriorates through prolonged use of
dishwasher cleaning.
4. Wipe the motor unit with a damp cloth. Never immerse it in water for cleaning as a electric shock may occur.
5. Dry thoroughly.
Caution: Blades are very sharp, handle with care.
Quick cleaning
Between processing tasks, hold the hand-held blender in the cup half lled with water and turn on for a
few seconds.

6
Instruction for blender
Instruction for chopper
1.Max operation duration per time should less than 1 minute, and 3 minutes rest time must be
maintained at two consecutive cycles.
2.To assemble the detachable shaft with the motor unit, turn the shaft anti-clockwise direction until
tightened. To disassemble, just turn in the adverse direction.
3.Simply plug the hand-held blender to power outlet.
4.Lower the hand-held blender into food. Then press and hold the low speed button or high speed button
to start operating.
5.To stop the hand-held blender by releasing the low speed button or high speed button.
6. When blending carrot, cut carrot into small pieces, and place them into blending jar, the max quantify
of carrot can’t exceed 280g, then add 420g water, in every blending.
1.Max operation duration per time should less than 30s, and 3 minutes rest time must be maintained at
two consecutive cycles.
2.Place the chopper bowl on a clean, level surface.
3.Assemble the stainless chopping blade into the chopper bowl, as shown in below gure.
4.Place food into the chopper bowl.
Note: remove the bone of the meat, cut small piece, then place the meat into bowl, the max quantity of
meat can’t exceed 200g in every blending.
5.Attach the lid onto the chopper bowl by pressing it down. To detach the lid by lifting it up.
6.Insert the motor unit into the hole of the chopper lid.
7.Lower the hand-held blender into food. Then press and hold the low speed button or high speed button
to start operating.
8. To stop the appliance by releasing the low speed button or high speed button of the motor unit.
9. After nishing chopping, unplug the power outlet rstly, then remove the motor unit from the chopper
lid by turning it in anti-clockwise.
10. Open the chopper lid by turning it in anti-clockwise and remove the chopped food.
Caution:
-To reduce the risk of injury, never place cutting blade on base without rst putting bowl properly in place.
-Be sure chopper lid is securely locked in place before operating appliance.
-During operating or after chopping, for safety, you shall disassemble the motor unit from the chopper
lid rstly, then remove the chopper lid. Never remove the chopper lid with the motor unit in place.

5
Using your blender
Know your blender (It is suitable for blending vegetable and fruit)
Before the rst use, clean the blender according to the section of “quick cleaning”.
The time running unit without load can’t exceed 15s.
Important: Blades are very sharp, handle with care. Ensure that the hand-held blender is unplugged
from the power outlet before assembling or removing attachments.

4
Know your blender (It is suitable for blending vegetable and fruit)

3
Know your blender (It is suitable for blending vegetable and fruit)

2
IMPORTANT SAFEGUARDS
Before using the electrical appliance, the following basic precautions should always be followed
including the following:
1. Read all instructions.
2. Before using check that the voltage of wall outlet correspond to the one shown on the rating plate.
3. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or
is dropped or damaged in any manner. Return appliance to the nearest authorized service facility for
examination, repair or electrical or mechanical adjustment.
4. If the supply cord is damaged it must be replaced by the manufacturer or a authorized service agent
or a qualied technician in order to avoid a hazard.
5. Always disconnect the blender from the supply if it is left unattended and before assembling,
disassembling or cleaning.
6. Do not let cord hang over edge of table or hot surface.
7. Do not immerse upper part of blender into water as this would give rise to electric shock.
8. Close supervision is necessary when your appliance is being used near children or inrm persons.
9. Avoid contacting moving parts.
10. Keep hands and utensils out of container while blending to reduce the risk of severe injury to
persons or damage to the blender. A scraper may be used but must be used only when the blender is
not running.
11.The appliance cannot be used for chopping ice or blending hard and dry substance, otherwise the
blade could be blunted.
12. To reduce the risk of injury, never place cutting blade on base without rst putting bowl properly in place.
13. Be sure chopper lid is securely locked in place before operating appliance.
14. The use of accessory not recommended by the manufacturer may cause injuries to persons.
15. Do not operate the appliance for other than its intended use.
16. Children should be supervised to ensure that they do not play with the appliance.
17. This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made
by children unless they are older than 8 and supervised.
18.Save these instructions.
19. The use of accessory not recommended by the manufacturer may cause injuries to persons.
20. Before removing the lid from the jar, release the button and unplug the appliance, wait until the
blades have come to a complete stop.
21. Always remove the blade assembly before pouring contents from jar.
22. Be sure to switch off the appliance after each use of your food processor. Make sure the motor
stops completely before disassembling.
23.The metal blades are extremely sharp,please handle carefully.
24.Always hold the blade stem instead of cutting edge when handling and cleaning the blade.
25. Be care of potential injury from misuse.

THB-600MTHB-600M
Hand Blender
Thanks for Choosing Tornado
Hand Blender
Table of contents
Languages:
Other ELARABY Kitchen Appliance manuals
Popular Kitchen Appliance manuals by other brands

Chicago Electric
Chicago Electric 93011 Assembly and operating instructions

Elgento
Elgento E26005 Important information

Metcalfe
Metcalfe EP10 Service manual

Nostalgia Electrics
Nostalgia Electrics CCM-527 instruction manual

Vollrath
Vollrath Redco Instacut 5.0 Operator's manual

SEVERIN
SEVERIN FLEISCHWOLF-AUFSATZ ZT 9751 Instructions for use