Electro-Voice 635N/D User manual

635N/D,635N/D-B
Omnidirectional
Dynamic
Microphones
General Description: Technical Specifications:
:tnemelEgnitareneGMYD/NcimanyD
®
erutcurtStengaM
:esnopseRycneuqerFzH000,31-08
:nrettaPraloPlanoitceridinmO
:)woL(ecnadepmIsmho051
tiucriCnepO,ytivitisneS :egatloV lacsap/Vm8.2
:rotcennoCenohporciMepyt-RLX,nip3
:ytiraloPniPotdecnereferevitisopeblliw2niP mgarhpaidnoerusserpevitisophtiw3
:lairetaMesaCleetS
,snoisnemiD :htgneL).ni48.5(mm841
:retemaiD.xaM).ni24.1(mm63
:hsiniFegieBnwaF-D/N536 kcalb"aremaC"ssolg-imeS-B-D/N536
:thgieWteN)zo6(g071
:thgieWgnippihS)zo6.02(g485
:dedulcnIseirosseccAretpadAdnatS113
:seirosseccAlanoitpOneercsdniWE413
Key Features:
• Neodymium (N/DYM®) Magnet Provides
Greater Output than with Standard Ferric
Magnets
• Rugged Design
• Choose Nonreflecting Fawn Beige or
Semigloss “Camera” Black
• Comes Complete with Stand Adapter
The Electro-Voice® 635N/D and 635N/D-B dynamic omni
directionalmicrophonesareoffspring ofthe legendary635A
microphone.Built with the same ruggeddesign ofthe 635A,
the 635N/D and 635N/D-B offer a neodymium N/DYM®
magnet structure for greater sensitivity. Designed for
increased ruggedness to meet the demands of exacting
professional applications, the 635N/D’s and 635N/D-B’s
are ideally suited for electronic news production (ENG),
electronic field production (EFP), television, film and radio
remotes and demanding PA applications.
The microphone’s Acoustalloy® diaphragm permits a very
smooth response over a wide frequency range, yet it
withstands high humidity and temperature extremes,
corrosive effects of salt air and severe mechanical shocks.
The diaphragm is protected from dust and magnetic
particles by a carefully designed integral windscreen and
blast filter. The windscreen provides excellent protection
from wind noise, excessive sibilance and annoying
“P-popping.” This helps minimize the need for an external
windscreen for outdoor use.
The 635N/D comes in nonreflecting fawn beige; the 635N/
D-B comes in semi gloss black for “on camera” use. The
increased output level and low sensitivity to mechanical
shock make the 635N/D and 635N/D-B excellent for
interviews,sporting events,special effects and voice-overs.
Both microphones come with the 311 stand adapter.

12000 Portland Avenue South, Burnsville, MN 55337
Phone:[phone], Fax:[phone]
www.electrovoice.com
© Telex Communications, Inc. 3/2006
PartNumber534671 RevB
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: [phone]
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 736-4212
For warranty repair or service information, contact the Service Repair department at:
800/553-5992 or 402/467-5321
For technical assistance, contact Technical Support at:
800/392-3497 or 952/736-4656
Specifications subject to change without notice.
Dimension Drawing:
Frequency Response: Wiring Diagram:
Architects’ and Engineers’
Specifications:
The microphone shall be an omni directional dynamic type with
wide-range response uniform from 80 to 13,000 Hz. It shall
have a nonmetallic diaphragm and an internal pop filter and
magnetic shield to prevent dust and magnetic particles from
reaching the diaphragm. The impedance shall be such that the
microphone will match 50-, 150- and 250ohm inputs. The line
shall be balanced to ground and phased. The output level shall
be 2.8 mV/pascal. The magnetic circuit shall be nonwelded and
employ a neodymium alloy magnet. The microphone shall have
a maximum diameter of 36 mm (1.42 in.), a length of 148 mm
(5.84 in.) and a weight of 170 g (6 oz). Finish shall be
nonreflecting fawn beige (635N/D) or semi gloss black (635N/
D-B). The microphone shall have a built-in XLR-type connector,
and shall include a 5/8”-27 thread stand adapter. The
Electro-Voice 635N/D and 635N/D-B are specified.
635N/DPartNumber:
• 6352332
635N/D-BPartNumber:
• 6352333