Electrolux UniRapido User manual

1

2
Thank you for choosing an Electrolux UniRapido vacuum cleaner. UniRapido is a rechargeable stick vacuum cleaner intended for use
on light dry household debris. In order to ensure the best results, always use original Electrolux accessories. They have been
designed especially for your vacuum cleaner.
BEFORE STARTING
•Unpack all details and check that the package includes all accessories relating to your UniRapido.
•Read the Instructions for Use carefully.
•Pay special attention to Safety advice chapter.
Enjoy your Electrolux UniRapido!
TABLE OF CONTENTS
Unpacking and charging 3-4
Cleaning the filters and dustcontainer 5
Cleaning brush roll, wheels and bellows 6
Removing the batteries and disposal 7
Safety precuations 8
Consumer information 9
DESCRIPTION OF YOUR UNIRAPIDO
1 Soft touch handle
2 On/off button
3 Charging/running indicator light
4 Container release button
5 Dust container
6 Parking rubber knob
7 Locking screw
8 Brush roll
9 Brush roll release button
10 Hatch cover for brush roll
11 Fine filter (inner filter)
12 Pre filter (outer filter)
13a Charging station, floor unit
13b Charging station, wall unit
14 Adaptor

3
UNPACKING AND ASSEMBLY
1 Fit the handle by carefully inserting it
into the lower main body Make sure
that the cable does not jam.
2 Secure the handle by tightening the
locking screw supplied Use a
screwdriver or a coin.
1 Position the charging station close to
a mains (well away from heat
sources, direct sunlight or wet
places) Insert the adaptor into the
mains socket and connect it to the
charging station.
2 The wall unit can also be mounted on
a wall Always ensure that the wall
can bear the weight of UniRapido.
CHARGING STATION

4
UNPACKING AND CHARGING
CHARGING
1 Place UniRapido in the charging
station always make sure that
UniRapido is turned off when placed
in the charging station .
2 charging!
First use: up to 24 hours charging
Fully discharged: 16 - 24 hours charging
Leave UniRapido on charge when not in
use. Warm adaptor is normal.
START/STOP
2 Charging!
1 Start UniRapido by pushing the on/off
button
A Press for start/stop (Start on
maximum cleaning power)
B Press for intermediate power
VACUUMING FLOORS AND CARPETS
Avoid scratching sensitive areas by
checking that nozzle wheels and brush
roll are clean.

5
CLEANING THE FILTERS AND DUSTCONTAINER
UniRapido’s dust container must be
emptied regularly, plus dust container
and filters need to be cleaned to maintain
a high suction power.
Clean the filters every third emptying or
when UniRapido has low suction power
Make sure parts are dry before
reassembling.
1 Release the whole dust container by
pushing the release button. 2 Take out both filters.
3 Empty the content into a wastepaper
basket. 4 Separate filters. Shake them clean or rinse separately using warm water.
Make sure fi lters are dry before
reassembling in reverse order.
5 Put the filters back and press back
the dust container in reverse orde.r

6
CLEANING BRUSH ROLL AND WHEELS
If the brush roll becomes blocked or
jammed, a protection circuit will block the
power supply to the motor. Then clean
the brush.
1 Push the brush roll release button.
The hatch cover will come slightly free
and the brush roll can now be
removed.
2 Carefully use a sharp object to
remove hair or threads. Replace the
brush roll and make sure that it fi ts
into its guiding tracks, and that it can
spin freely. Replace the hatch cover.
1 If the wheels needs to be cleaned,
remove them carefully by using a
small screwdriver.
2 Remove objects that have become
jammed in the wheel shafts.
Reassemble the wheels by pressing
them back into their tracks.
1 Occasionally objects can get stuck in
the bellows, and this can affect
suction power. Clean the bellows
after removing the dust cup.
CLEANING THE BRUSH ROLL
CLEANING THE WHEELS CLEANING THE BELLOWS

7
DISPOSAL
REMOVING BATTERIES
Only remove batteries if product is to be
scrapped.
1 Run batteries fl at and disconnect
UniRapido from the charging station
Undo the 11 screws (2 of them hidden
under the release button).
2 Release the button and carefully lift
the hood. 3a Unclip the connecting cables and lift out the batteries Batteries should be
removed from the appliance before it
is scrapped.
3b Unclip the connecting cables and lift
out the batteries Batteries should be
removed from the appliance before it
is scrapped.
Used batteries should always be
taken to a recycling Station.

8
SAFETY PRECUATIONS
UniRapido should only be used by adults and only for normal vacuuming in adomestic environment. Make sure the vacuum cleaner
is stored in a dry place. Allservicing and repairsmust be carried out by an authorized Electrolux service centre.
This appliance is notintended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Please remove the plug from the socket outlet before cleaning or maintaining the appliance.
Children should be supervised to ensure that they do not play with the appliance.
Each vacuum cleaner is designed for a specific voltage. Check that your supply voltage is the same as that stated on the rating
plate. Use only the original charging adaptor designed for this model.
Never use the vacuum cleaner
•In wet areas.
•Close to flammable gases, etc.
•When housing shows visible signs of damage.
•On sharp objects or fluids.
•On hot or cold cinders, lighted cigarette butts, etc.
•On fine dust, for instance from plaster, concrete, flour, hot or cold ashes.
•Do not leave the vacuum cleaner in direct sunlight.
•Avoid exposing the vacuum cleaner or battery to strong heat.
•The battery must not be dismantled, shortcircuited, placed against a metal surface or exposed to strong heat.
•Without filter.
Using the vacuum cleaner in the above circumstances may cause serious damage to the product. Such damage is not covered by
the warranty.
Servicing or repairs
In cases of breakdown or faults, your UniRapido must be taken to an authorized Electrolux service centre. If the supply cord is
damaged, it must be replaced by Electrolux or its service agent or a similarly qualified person in order to avoid a hazard.

9
CONSUMER INFORMATION
Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering
with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to
avoid a hazard.
This product is designed with the environment in mind. All plastic parts are marked for recycling purposes.
For details see our web site:
www.electrolux.com
If you have any comments on the cleaner or the Instructions for Use booklet please e-mail us at:
[email protected]
If you can´t find accessories to your Electrolux vacuum cleaner, please visit our website at
www.electrolux.co.uk
or call 08706 055 055.