Electroswitch Arga 25-1000 User manual
QS BM0818 2
1. Manual or Continuous Scanning of Limits and settings
a. To manually scan/scroll through all the limits and setting short press
the SC N/M NU L button
b. To enable the unit to automatically scan/scroll through all the limits
and setting long press (approx. 4 sec) the SC N/M NU L button
c. To go back to manual scanning mode press and hold (approx. 4 sec)
the SC N/M NU L button
2. Reset Alarm Relay Contacts
a. Press the RESET button.
Note: ll fault conditions must be cleared in order to reset alarm relays
3. Alarm Limits and Settings
From monitor (operating) MODE
a. Press and Hold LIMIT button (approx. 4 sec)
LMIT is now flashing in the lower display
b. Short press LIMIT button
HBAT flashes in the lower display and the voltage value
in the upper display
c. Use the UP / Down buttons to adjust the HBAT limit voltage in the
upper display
d. When completed, short press the LIMIT button to move to the next
alarm limit parameter and repeat step C
e. When all the alarm limit parameters and setting (see below) are set
Press and Hold the limit button for approx. 4 sec to get back to
monitor mode. Note: In order to go back to monitor mode you must
be in one of the menu items in FIG. 1
FIG. 1
QS BM0818 3
4. Alarm Enable / Disable
From monitor mode
a. Press and Hold LIMIT button
LMIT is now flashing
b. Short press the LIMIT button until you scroll through to “SYS”
SYS and the software version is displayed
c. Press and Hold LIMIT button
AC Y/N will be displayed in the lower readout
d. Use the UP /DOWN buttons to enable or disable the system alarms
shown above and short press the LIMIT button to scroll through
e. To exit press and hold LIMIT button -> goes back to SYS, short press
LIMIT button -> goes to C L, short press LIMIT button -> goes to LMIT,
long press (approx. 4 sec) LIMIT button -> goes to monitor mode
5. Address and Baud Rate change
a. Repeat step 2 a, b and c above
b. Short press the LIMIT button until you scroll through to “SYS”
SYS and the software version is displayed
c. Short press the LIMIT button to scroll through to ADDR and use
UP / DOWN buttons to select the address
d. Short press the LIMIT button to move to B UD and the UP
/DOWN button to select the baud rate
e. To return to monitor mode long press the LIMIT button
a
6. Calibrate Analog Output and Adjust Displayed Battery Voltage
&
This manual suits for next models
3
Table of contents
Other Electroswitch Measuring Instrument manuals
