
Trouble Shooting:
10
How It Works:
Connect the adaptor to the mains, the clock will start countdown 9.8.7….2.1.0.
Later, the Hour LED will start flashing and stay at 12:00.
Push the 'SET' button once or twice, the Minute LED will start to flash, push the
'MODE' button to adjust the minutes.
Push the 'SET' button, the Hour LED will flash, push 'MODE' button to adjust
the hours.
Push the 'SET' button again, the clock starts to work. At this time, use 'MODE'
button to select the presentations of the hour. There are 2 different hours'
presentations, normal and rotating.
There are 8 different minutes display which will show sequentially when the
minutes change to the next.
Make sure the adaptor connects well on the 2 ends.
Check if the white 'BAT' terminal connects well.
Make sure if the wirings of the 'SET' and 'MODE' buttons are correct.