Element Rapid Recovery 6224 User manual

Rapid Recovery™ Kinetic Winch Installation Instructions
Covers Part #6224 (Element RC)
Kit Contents:
●35" x 1/8" Kinetic Shock Cord (1 Piece)
●Stainless Steel Multi Hook (1 Piece)
●Aluminum Pulley with Bearings (2 Pieces)
●M3x10 Button Head Screws (2 Pieces)
●M3x12 Button Head Screws (2 Pieces)
●M3x16 Button Head Screws (5 Pieces)
●M3 Flat Washers (2 Pieces)
●M3 Shoulder Screw (1 Piece)
●M2.5x8 Socket Head Screws (2 Pieces)
●Element RC Mount Set (5 Pieces)
Attaching the Multi Hook to the Kinetic Cord
1. Put the loop end over the shoulder screw in the front
mount or on the chassis depending on your setup.
2. Route the cord through the chassis back around the
pulley then back up through the front rope guide or
fairlead. Mark 1” back from the rope guide and cut the
cord. Burn the cut end with a flame.
3. You can remove the cord off of the pulley for some
slack to make installing the hook easier and then route
the cord back through the rope guide before securing
the hook with a figure 8 knot as shown in the diagram
below.

Enduro, Trailwalker, Trailrunner & Knightrunner
1. Install the pulley onto the rear pulley mount with a
M3x16 screw with a washer in between the pulley
and the mount.
2. Install the rear pulley bracket by replacing the
rear bumper mount screws with the included
M3x12 screws.
3. Install the front pulley mount to the backside of
the shock tower with two M3x10 screws
4. Install the shoulder screw for the loop end of the
kinetic cord into the front of the mount.
5. Install the pulley to the mount with a M3x16 screw
with a washer in between the pulley and mount.
6. Install the kinetic cord as shown on the other side
of the instructions.
Gatekeeper & Ecto
1. Install the pulley onto the rear pulley mount with a
M3x16 screw with a washer in between the pulley
and the mount.
2. Install the rear pulley bracket by replacing the
rear bumper mount or body post mounting screws
with two M3x12 (for body mounts) or M3x16 (for
bumper mount) screws. Do not overtighten.
3. Install the front rope guide to the underside of the
front bumper mount with two M3x16 screws. Do
not overtighten.
4. Install the kinetic cord as shown on the other side
of the instructions.