©Eliminator® Los Angeles, CA. - www.EliminatorLighting.com
Color Mode:
In this mode you can choose a desired color to remain static.
1. Plug the fixture in and press the MODE button until “C.L.X” is displayed. “X” = 0-7.
2. Press the UP or DOWN buttons to adjust “X” between 0-7.
Color Change Mode:
In this mode the unit will change through the different colors.
1. Plug the fixture in and press the MODE button until “J.XX” is displayed. “XX” = 01-99 which is the adjust-
able rate of the speed change.
2. Press the UP or DOWN buttons to adjust the speed of the color change.
Color Fade Mode:
In this mode the unit will fade in and out of the different colors.
1. Plug the fixture in and press the MODE button until “F.XX” is displayed. “XX” = 01-99 which is the adjust-
able rate of the speed change.
2. Press the UP or DOWN buttons to adjust the speed of the color fade.
Auto Mode:
1. Plug the fixture in and press the MODE button until “A--” is displayed.
Sound Active Mode:
In this mode the unit will react to sound, changing and fading through the different colors.
1. Plug the fixture in and press the MODE button until “S.XX” is displayed. “XX” = 00-31 which is adjustable
sound sensitivity levels.
2. The fixture will now change via sound. You can adjust the sound sensitivity by pressing the UP and DOWN
buttons. The sound sensitivity can be adjusted from 00 - 31, 00 being the least sensitive, and 31 being the
most sensitive.
OPERATION:
UNIVERSAL DMX CONTROL:This unit allows you to use any universal DMX-512 controller to LED color and
the shutter (strobe). A DMX controller allows you to create unique programs tailored to your individual needs.
Follow the set-up specifications that are included with your DMX controller.
1. The Electro 64 BLED has an 4 DMX Channels.
2. Press the UP button until “XXX” is displayed, press ENTER. (“XXX” represents the displayed address)
4. Now press the UP button to set your desired address and press ENTER. Connect your DMX Controller.
5. Use the controller’s faders to control the various DMX fixture traits.
6. For longer cable runs (more than a 100 feet) use a terminator on the last fixture.
7. For help operating in DMX mode consult the manual included with your DMX controller.
Master-Slave Configuration:
This function will allowsyou to link units together to run in a Master-Slave mode. In Master-Slave operation
one unit will act as the controlling unit and the others will react to the controlling units built-in programs. Any
unit can act as a Master or as a Slave however, only one unit can be programmed to act as the “Master.”
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR microphone cables
to link your units together. Remember that the Male XLR connector is the input and the Female XLR con
nector is the output. The first unit in the chain (master) will use the female XLR connector only. The last
unit in the chain will use the male XLR connector only.
2. Using the Master unit, choose your desired operating mode and connect the “Slave” unit or units.
3. For the “Slave” unit(s) press the MODE button until “S.L.A.” is displayed. They will now follow the
“Master” unit.
