Eliminator Lighting Moon Beam User manual

©Eliminator® Los Angeles, CA. - wwwEliminatorLighting.com
E 103
SPECIFICATIONS:
Model:
E 103
Weight:
5 lbs.
Size:
4.5”H x 4.5”W x 8.5”L
Lamp
: ZB-64610 12V 50W
Fuse:
1A
Supply Voltage:
120V
Working Position:
Any Safe position
Colors:
Multiple Colored Dish
Duty Cycle:
15min on/off
Warranty:
1 Year Limited Warranty
CAUTION!
Please read and
understand these instructions
before installing or operating
this unit.
Lamp Replacement:
Remove the two
thumb screws from the front of the unit.
Gently pull the front lens assembly forward
to access the lamp. Remove and replace
the bad lamp and reassemble in reverse
order.
HALOGEN LAMP WARNING!
This fixture is fitted with halogen
lamps which are highly susceptible
to damage if improperly handled.
Never touch lamp with bare fingers
as the oil from your hands will short-
en lamp life. Also, never move fixture
until lamp has had ample time to
cool. Remember, lamps are not cov-
ered under warranty conditions.
Caution!
Never open unit when in use.
Always disconnect main power before
serving or replacing lamp. Remember to
always replace with the exact same type
lamp and fuse.
Operating Instructions:
The unit is ready to be hung
or set on flat surface.
This fixture is designed to oper-
ate as a stand alone unit. It has been tested and the
lamp has been installed at the factory there is no
assembly necessary.
The E103 has three different
operating modes. For best results, we suggest using
fog or special effects smoke when using this unit.
This will enhance the effect allowing you to see the
beams of light.
This unit comes with a 3-way
multi-
operating switch
located on the
rear
of the unit.
The switch controls
three (3) different operating modes; Static, Sound
Active, and Continuous Rotation. When the switch
is in the "I" position
the internal dichroic dish spin
continuously and
the
barrel mirror
will react to
sound,
via its internal microphone. When the unit is in the
"0" position
the internal dichroic dish is static (does
not rotate) and
the
barrel mirror
will react to
sound
.
When the switch is in the "II" position the unit's
inter-
nal dichroic
color wheel
and barrel mirror
will
react to
sound.

©Eliminator® Los Angeles, CA. - wwwEliminatorLighting.com
1 Year Limited Warranty:
Eliminator Lighting warranty is valid from the date of purchase. Our 1 year
limited warranty covers manufacturing defects only. Serial number, place of purchase with dated
valid receipt must be submitted at time of service. Eliminator Lighting warranty does not cover items
or parts prone to wear and tear: lamps, fuses, brushes and belts. Eliminator Lighting warranty is only
valid with-in the United States.