Eliminator Lighting EZ8 System User manual

EZ8 System SPECIFICATIONS:
Model: EZ8 System
Supply Voltage: 120V 50Hz
Weight: 5 lbs./2.3kgs
Size: 11.75”L x 8.75”W x 6”H
Fuse: 1 Amp
Power Consumption: 30W
Working Position: Any Safe position
Duty Cycle: None
Warranty: 1 Year
CAUTION! Please read and understand these
instructions before installing or operating this
unit.
Operating Instructions:
The EZ8 System is an on/off power control center designed to eliminate messy cables. The EZ8
System features 8 on and off switches, 15 amps, and a 25 ft. cable. It’s ideal for switching lighting
and audio equipment on and off.
©Eliminator® Los Angeles, CA. - wwwEliminatorLighting.com
Caution! Never open unit when in use.
Always disconnect main power before
replacing the fuse. Remember to always
replace with the exact same type of fuse.
1 Year Limited Warranty: Eliminator Lighting warranty is valid from the date of purchase. Our
1 year limited warranty covers manufacturing defects only. Serial number, place of purchase with
dated valid receipt must be submitted at time of service. Eliminator Lighting warranty does not cover
items or parts prone to wear and tear: lamps, fuses, brushes and belts. Eliminator Lighting warranty
is only valid with-in the United States.

©Eliminator® Los Angeles, CA. - wwwEliminatorLighting.com
CONTROLS AND COMPONENTS:
1. MASTER ON/OFF SWITCH.
2. INDIVIDUAL CHANNEL SWITCHES.
3. FLASH ON BUTTON FOR EACH INDIVIDUAL CHANNEL.
4. 9 PIN LINE OUT CONNECTOR.
5. 12V POWER SUPPLY
6. FUSE
7. CHANNEL 1-8 110V SWITCHED SOCKETS.
8. UNSWITCHED 110V SOCKET FOR CONSTANT ON ITEM OR LINKING AC
TO ANOTHER RELAY PACK.
9. 9 PIN LINE OUTPUT FOR LINKING PACKS.
10. 9 PIN LINE INPUT FROM SC-8FC OR FROM ANOTHER SC- RP8.
11. 15 AMP CIRCUIT BREAKER.
12. A/C CORD AND PLUG.
1 2
465
7
312 11 10 9
8
Important Notice: Never attempt to run more than 2 power packs per a controller -
More than 2 power packs can cause damage to the controller and power packs!
A/C A/C
SAMPLE SET UP