eMachines T2341 User manual

T2341 BIOS Flash Instructions
To Flash Your System BIOS, Follow The Instructions Below
WARNING ! Interrupting, or powering off your system during the flashing process
could permanently damage your system.
1. Download the self-extracting BIOS Utility and the BIOS flash instructions from
the web site.
2. Once the download completes, double-Click on the file named T2341_1.10e,
located on your desktop and follow the instructions to extract all the files to a
floppy disk. NOTE: All files on this floppy will be erased!
3. When the WinImage Self-Extractor Dialog box appears,click 'OK' to extract
the files to the floppy disk.
4. When the message box stating 'Insert floppy to write' appears, make sure
that your floppy diskis in the drive and click 'OK'.
5. If the following message appears: 'Disk is not empty, all data on your disk will
be lost. Do you want to continue?' please replace the floppy disk with an
empty one, otherwise all data on the floppy disk will be erased. . Then click
'Yes'.
6. When the extracting completes and the WinImage Self-Extractor Dialog box
disappears, leave the disk inserted in the disk drive, and reboot your
computer.
7. The system will boot to the floppy and short flash utility will take place--DO
NOT INTERRUPT THIS PROCESS,
8. When the update process is finished you will see an “A:>” prompt at the
bottom of the screen. It is very important to wait until the process completes.
9. Please eject the floppy disk and then restart your system but pressing the
power button.
10. At this point you have successfully flashed your system’s BIOS.
.