Assembly Instruction
Item # 277-5539
Tiered Fountain
* * WARNING * *
Read these instructions carefully and keep the fountain power off until the following
assembly process is completed.
Notes:
Choose an appropriate location for the fountain.
Excessive weight or pressure on any of the fountain sections may cause it to fall. Keep pets, children, or anyone
from sitting, leaning, or climbing on any of the fountain components.
While fountain is designed to operate as splash free as possible, some water splashing out of the fountain is
inevitable. Place the fountain in a location where any splashing will not cause damage. Always keep the fountain
working with sufficient water and clean of debris and dirt to ensure proper functioning of the pump.
If necessary, clean the fountain with a soft cloth and change the water frequently. Due to water evaporation, you
may see a buildup of white residue on the fountain surface from mineral content in the water supply. To prevent
such buildup, regularly clean the fountain with mild soap and water, do not use any abrasive, which may damage
the applied finish
See the pump instructions for pump safety, maintenance, and warranty information. Keep this manual for future
reference.
Use of water clarifier, or algaecide of any kind will damage the paint on the fountain and will not be covered under the
manufactures warranty.
Installation &Assembly
Take out all the package parts from the carton
Assemble the fountain as outlined in the below steps
Step 1: Screw part C to part B and make sure the two arrows can match each other; Showed as in diagram 1
Step 2: Place the fountain in an even surface., As the water flow will be affected if the surface is uneven
Shown as in diagram 2
Step 3: Place the pump into part B and pull the pump wire out of the pipe. Shown as 3a in diagram 3
Step 4: Connect the pump to water pipe. Showed as 3b in diagram 3. Make sure the water pipe is straight and
not twist together. As this may prevent water from coming in.
Step 5: Screw part A to part B and tighten two bolts Showed as 4a, Apply the door to fountain Showed as 4b
in diagram 4
Step 6: Fill fountain with enough water to full submerge the pump and plug the pump to the socket, The water
will start to flow in minutes. Shown as 4c and 4d in diagram 4
Attention: Always make sure the water can submerge the pump completely to work properly and prevent the
pump damage.
Adjust the pump flow rate to achieve the desired effect and to minimize any splashing. Splashing can occur if the
flow rate is too high or the reservoir is too full. The flow rate can be increased or decreased by moving the flow
rate control dial on the pump body. Moving the switch towards ‘+/ Max’ will increase the flow rate and moving it
towards ‘-/Min’ will decrease it.
