Enchanted Garden 2775542 User manual

DO NOT RETURN TO RETAILER
IF YOU HAVE ANY
QUESTIONS OR CONCERNS
PLEASE CALL
BOND MANUFACTURING
TOLL FREE AT
+1-866-771-BOND(2663)
MONDAY – FRIDAY 8AM TO 4:30 PM PST
OR EMAIL TO
Customer[email protected]
OR VISIT OUR WEBSITE AT
www.bondmfg.com
Model# 2775542

Assembly Instructions
Item#: Y95857
* * WARNING * *
Read these instructions carefully and keep the fountain power off until the following
assembly process is strictly completed.
Step (1) Pull out the flexible hose from the inside of the fountain, then connect it to pump outlet,
shown in ②.
Step (2) Find the cable line of the light from the inside of the fountain and pull it out from the
back hole, shown in ④, then connect it with the adaptor, shown in ③.
Step (3) Place the strainer mesh into the fountain, and put the cover on the top of the fountain,
shown in Figure ‘1’.
Figure ’2’
Fill the reservoir with clean water carefully. Always make sure the water is high enough to submerge the
pump completely. This ensures the pump can work properly and prevents damage to the pump.
Plug the pump and adaptor then switch on, the water will start to flow in minutes, and lights will be
shining instantly.
Adjust the pump flow rate to achieve the desired effect and to minimize any splashing, shown in (F).
Splashing can occur if the flow rate is too high or the reservoir is too full. The flow rate can be
increased or decreased by moving the flow ratecontrol slider on the pump body. Moving the slider
towards ‘+/Max.’ will increase the flow rate and moving it towards ‘-/Min’ will decrease it.
On some types of pumps, the flow regulator may be turned clockwise or counterclockwise to adjust.
1

2

Troubleshooting
-- TURN OFF THE POWER BEFORE YOU CHECK FOLLOWING--
If pump does not run, or lights are not on --
(1) Check the circuit breaker, try another outlet.
(2) Check the water level in the fountain. Running the pump without sufficient water can damage the pump.
(3) Check the setting of the flow control on the pump and adjust the flow.
(4) Check the pump discharge and intake for dirt and debris.
(5) Check the fountain feature tubing for kinks and obstructions.
(6) The pump might be “air locked”. Plug and unplug the pump several times to release the air inside the
pump.
(7) Check and reconnect all the cords and try again.
IF YOU HAVE QUESTIONS OR CONCERNS PLEASE
CALL BOND’S TOLL FREE #
1- 866- 771 - BON D (2663) OR TO BETTER
EXPEDITE YOUR REQUEST FEEL FREE TO EMAIL US
customer[email protected]
OR LOG
IN TO OUR WEBSITE UNDER CUSTOMER SERVICE SUPPORT
www . bondmfg . com
3

4

5

6

7