Enchanted Garden 2775231 User manual

INSTRUCTION MANUAL
Sku#2775231
31” Metal Pitcher Fountain
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
DO NOT RETURN THIS FOUNTAIN TO THE STORE
PLEASE READ THE FOLLOWING FIRST
CUSTOMER SUPPORT CENTER
Thank you for purchasing your new fountain.
Carefully check all packaging materials before discarding.
Do not assemble if there are missing pieces.
Should you encounter problems after following all the steps herein contained please contact our
Customer Support: email: [e-mail]
Kindly provide the model #, place and date of purchase and a short description of the problem.
LIMITED WARRANTY
This product has a Three month’s Limited Warranty. This warranty is limited to the replacement of defective parts only. Labor
charges and/or damage incurred during installation, repair, replacement as well as incidental and consequential damages
connected with the above are excluded. Any damage to this product as a result of neglect, misuse, accident, improper installation
or use other than the purpose SHALL VOID THIS WARRANTY.

ASSEMBLY INSTRUCTIONS:
ARTICLE / ITEM: H160038White Metal fountain
1. Place base on a clean level area outdoors. Do not place on or near surfaces that may be damaged by water.
2. Fountain needs to be located near a GFCI (Ground Fault Circuit Interrupter) outdoor electrical outlet.
3. To prevent back injuries, please ask for assistance when lifting.
ASSEMBLY:
1- Set the basin facing toward you with the braces toward the back.
2- Put the short section to the left with the pitcher spouts facing the center.
3- Use the allen wrench and spanner to fasten 2 nuts and screws from the plastic bag to hold in place.
4- Install the tall section by first threading the hose through the bracket, the put in place and fasten with two
screws and nuts.
5- Hook the hose to the pump. Drape the electrical cord over the back.
6- Fill basin with clean water.
7- Plug the pump cord into a properly grounded outlet (GFCI).

Assembly Diagram
General Information:
- Pump (cULus Listed)model number: YF-650 AC 120V 60Hz. 0.085 A
- Power cord is 6ft (1,83 m / 72 inch) long.

Troubleshooting:
If water does not flow out of unit, disconnect the power supplyand verify that there are no kinks in the
hose. Shake the pump a little while underwater; to remove any trapped air in the unit.
Remove any visible debris.
Make sure there is enough water in the fountain. Fill to within 1-2 inches below the rim of the base (Fountain – Lower Section).
Connect and disconnect the power a few times. The pump should function.
Wait a while in order to allow the water to circulate properly.
Care and Maintenance:
Keep the water clean at all times.
Remove all forms of debris.
Never run the pump dry.
Verify water level frequently to compensate for evaporation during the summer. Fill within 1-2 inches below the rim of the base
(Fountain – Lower section).
Not for operation below 41° F (5° C). All water must be removed from the unit in freezing conditions.
This fountain is for outdoor decorative use only.
This fountain is designed to function with water only.
Never leave a running fountain unattended.
The water in the fountain is not safe to drink.
Keep away from small children and pets.
Change the water regularly to prevent the proliferation of mosquitoes
INSTRUCTION FOR STORAGE: THE FOUNTAIN MUST BE STORED INDOORS DURING WINTER OR WHEN
TEMPERATURE IS BELOW 50°F (10°C)
During Winter, this fountain must be stored indoors Please follow the following steps:
- Disconnect power supply
- Carefully empty fountain of all water
- Store Indoor on water resistant surface
WARNING! RISK OF ELECTRICAL SHOCK!
This pump is supplied with a grounding conductor and grounding type plug. To reduce the risk of electric shock, be
certain that it is connected to a properly grounded, grounding type receptacle.
Always disconnect power supply before manipulating fountain.
Connect only to a grounded outdoor power outlet of 120V- 60Hz.
Do not attempt to repair a damaged pump/power cord. Ask for a replacement pump/cord from the manufacturer.
To avoid possible injuries do not tamper with pump/cord assembly.
Must be used only with the pump AND/OR transformer AND/OR adapter provided.
Be careful not to spill water onto the plug of the pump.
DO NOT allow the pump to run dry!

WARNING!
To reduce the risk of electrical shock, use pump only on self-contained fountains no larger than 5 feet (1.5 m) in any
dimension.
Precautions:
•Excessive weight or pressure on any of the fountain sections may cause it to tip or fall over. Keep pets and children away
from any of the fountain sections. Do not place any items, such as potted plants, on the edge of the bowl.
•If the entire fountain falls into the water accidentally, turn off the circuit breaker immediately before manipulating.
•Do not operate the fountain if the pump has been dropped or has a damaged
power cord or plug.
•If the plug or your wall receptacle gets wet due to water dripping down
the power cord or for any other reason, do not remove the plug from the
wall outlet until the circuit breaker is turned off.
•NOTE: Allow the pump power cord to hang at a lower level than
the wall outlet to form a “drip loop.” This will help prevent water
from dripping down the power cord and getting into the wall outlet.
•Periodically change the water. Clean the fountain water basin, the pump’s
outlet nozzle and the water tube for dirt and debris with a damp cloth if necessary.
•Keep the power cord away from high temperatures or heat sources.
Use only a CUL or CSA or CETL approved extension cord of the correct rating to avoid overheating.
Do not use attachments, which are not provided by the manufacturer, since they may cause an unsafe condition.
•This fountain pump is not intended for commercial use.
WARNING
IN ORDER TO PRESERVE THE BEAUTY AND THE LIFE OF THIS ITEM, IT IS HIGHLY
RECOMMENDED TO COVER WITH A CANVAS TYPE WATERPROOF MATERIAL OR STORE IN A
COVERED AREA FOR THE WINTER.