Enclume Pr1 User manual

Enclosed you will find everything needed for the assembly

and use of your storage rack. Two people make assembly

and installation easier. The parts and hardware included are:

Hardware included:

2 – Ceiling Screw Hooks

8 – 3/8” x ½” Button Head Screws

1 – 7/32” Allen Wrench

Components included:

1 – Rectangular Base

4 – Arms

1 – Upper Hanging Rectangle

12 – Angled Pot Hooks

12 – Straight Pot Hooks

1 – Grid

6 – Grid Brackets

See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS

PR1 - CLASSIC RECTANGLE

Thank you for choosing Enclume!

Enclume racks are the ultimate quality,

design, strength and function.

WARNING: READ ALL OF THE

INSTRUCTIONS BEFORE

ASSEMBLING AND USING YOUR

RACK

If you need help, please call 1-877-ENCLUME

Enclume Design Products

24 Colwell Street, Port Hadlock, WA 98339

Phone 360-385-6100 Fax 360-385-6156

www.enclume.com

ASSEMBLY AND INSTALLATION INSTRUCTIONS for PR1

Rack Assembly

1) If your rack is plated it is best to keep the tissue on during installation to avoid fingerprinting.

2) Locate the hardware bag containing the button head screws and allen wrench. Using the allen wrench, attach the arms to the

outside of the large rectangle with the screws, leaving the button head screws a little loose.

3) Attach the arms to the small hanging rectangle with the button head screws.

4) Square up the rack by aligning the arms so they are perpendicular to the upper and lower rectangles. Tighten all of the button

head screws.

Installation:

1) We recommend that you anchor your rack into the solid wood of ceiling joists or beams. Carefully measure the area where

the rack is to be hung and install the ceiling screw hooks directly into the wood joists. If you have a special situation such as

steel joists or masonry, please contact your local hardware store or contractor for expert advice.

2) If it is not convenient to hang your rack directly into wood joists you may use the included DRYWALL anchors enclosed

with your rack. Follow Toggler® brand manufacturer recommendations for weight limits included in the instructions in the

Toggler kit.

Grid Assembly

1) Slip the 6 grid brackets over the lower rectangular base with the “L” portion pointing to the inside. Center one bracket on

each end and one on the inside of each arm.

2) Place the grid on the brackets.

3) For your safety, distribute your cookware evenly. Hang your pot hooks from the interior squares only. Do not hang them

from the perimeter or the cut portions of the grid.

It is important that your rack is assembled correctly. If the unit is assembled or used

incorrectly, it could become unstable and collapse, possibly causing injury.

Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy shall

be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the

warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St. , Port Hadlock, WA 98339, postage prepaid within 20

days following a return authorization number (which may be obtained by telephoning the number at the top of this instruction) being provided to the customer by