Endless Pools EP3 Original operating manual

Programming Remote Control/Clearing Receiver (EP3) Service Instruction
Endless Pools D90038_en 0918
Programming Remote Control:
1. Press and hold the internal or external remote control
learn button until the remote control LED light on the
receiver board turns on.
2. Once the LED light turns on, release the remote control
learn button.
3. While the LED light is on, press and hold any button on
the remote control. The LED light will blink twice and then
turn off. The remote control is now programmed and linked
to the receiver board. Repeat the programming procedure
for any subsequent remote.
!"#$%$&& '$()*$ +),*#)%
-./ '$0$"1$# 2)3#4
'$()*$ +),*#)% 5-6 5"78*
9,*$#,3% '$()*$ +),*#)%
5$3#, 2:**),
-;*$#,3% '$()*$ +),*#)% 5$3#, 2:**),
<:,4$#&"4$ )= >)?$# :,"* 0),*#)%%$#@

Programming Remote Control/Clearing Receiver (EP3) Service Instruction
Endless Pools D90038_en 0918
Clearing Receiver:
1. Press and hold the internal or external remote control learn button until the remote control LED light
on the receiver board starts blinking rapidly.
2. Continue to hold the remote control learn button until the LED light goes out.
3. Once the LED light goes out, the !"#"$%"!&' memory has been cleared from any
previously linked remote controls.