ENDURISTAN LUSA-509 User manual

Enduristan GmbH 1 RD-000238
Installation guide
[LUSA-509] Monsoon Evo Diameter Extender
PACKAGE CONTENT
- 4x Monsoon Evo Diameter Extender Piece
ALSO NEEDED
- Allen key size 3
- [LUSA-008] Monsoon Evo
DISMANTLING THE BRACKETS ON YOUR MONSOON BAG AND FITTING THE DIAMETER EXTENDER
1. Leave the locking pins inside the bracket.
2. Remove the 4 screws on both mounting brackets from the
inside of the bag and remove the bracket and screws. Make sure
the self-locking nuts do not fall out of the bracket when
removing the brackets.
3. You can leave the counter plate and the screws in the bag.
4. Remove the 2 small parts and place on a table.

Enduristan GmbH 2 RD-000238
5. Place the two diameter extender pieces on the two
separated small parts and re-assemble the bracket.
6. Repeat step 1-5 for the other bracket.
(Step 7 - 9 are only applicable if you have removed the screws
and the counter plate from the bag)
7. Take 4 screws and put them into the counter plate.
8. Put the screws with the counter plate from the inside
through the bag. Make sure the reinforced middle part is
placed vertically.
9. Repeat step 7 and 8 for the other counter plate.
10. Place the mounting bracket on the screws. Make sure the
pulling strap is not pinched between the plastic and the
bag. Make sure the Enduristan Logo has the correct
orientation (longer stroke of the “E” facing down).
11. Tighten all the screws from the inside of the bag.
12. Repeat step 10 and 11 for the other bracket.