Eneo AK-21 User manual

AK-21 Quick Installation Guide (EN)
DIMENSION (Unit: mm) SPECIFICATION
PARTS SUPPLIED
PRIOR to USE
Install the mount onto a strong structure such as concrete wall
Use the supplied accessories when installing the mount bracket depends on mounting position
Construction: Aluminum Cast
Environment: Ceiling mount for a Bullet
Dimension(mm): ф134.3x56.50mm
Weight: 396g (0.87lb)
4 x Screws
4 x Expansion Bolt
Screw Driver
4 x Screws
Junction Box
Screws, Water-proof Rubber
Installation Template
QIG

AK-21 Quick Installation Guide (EN)
INSTALLATION
Ceiling Mount
Wall Mount
1. Locate the mounting template at the installation position and drill the wall.
2. Hammer the 4 expansion screws into the wall holes drilled
3. Route the power and BNC cable through the box
4. Tight the box base to wall through the four screws
5. Insert the box ring to the mounting plate for waterproofing
6. Tight the box cover to the box base through the four screws.
7. Connect the power and BNC cable with the camera cables
8. Set the camera’s viewing angle
9. Fix the bracket of camera to the box cover
The Junction Box allow you mount on the wall. Details operation steps please refer to the Ceiling Mount.