Eneo DOME-WB3 User manual

SPECIFICATION
PARTS SUPPLIED
INSTALLATION
T20 (Q’ty:1)
DIMENSION
(unit: mm)
Wall Mount Bracket
Installation
Guide
Mounting
Template
Trox Wrench
PRIOR to USE
Install the mount onto a strong structure such as concrete wall.
Use the supplied accessories when installing the mount bracket depends on mounting position.
Mounting Screw
BA4x30mm (Q’ty:4)
Assemby Screw
M4x11mm (Q’ty:4)
Plastic Anchor
6x26mm (Q’ty:4)
Aluminum cast
Wall mount for a Vandalproof dome
Ø158.90(W)x136(H)x237.75(L)
900g (1.98 lb)
Construction:
Environment:
Dimension(mm):
Weight:
Please Turn Over
Bracket PadBracket Ring
Mounting Screw
(BA4x30mm)
1. Locate the mounting template at the installation position and drill the wall.
2. Remove the release paper of bracket pad and attach to rear plate of the bracket.
3. Route the power and BNC cables through the bracket.
4. Place the mount bracket on pre-drilled position and
fix it through using mounting screws. Bracket Pad
3mm (Q’ty:1)
L-Wrench
Wall Mount Bracket
for Vandalproof dome
88.50
109.50
67.00
136.00
237.75
Ø158.90
184.60
Release Paper

INSTALLATION
Vandalproof dome unit
Assembly Screw
(M4x11mm)
Bracket Ring
Mounting Plate
Dome Cover
5. Insert the bracket ring to the mounting plate for waterproofing.
6. Open the dome cover by loosening screws.
7. Connect the power and BNC cables with the camera cables.
8. Assemble the vandalproof dome unit to the mounting plate using the assembly screws (M4x11mm).
9. Set the camera’s viewing angle.
10. Put the dome cover to the dome unit and tighten screws.
* The vandalproof dome is not
included in this package.
eneo® is a registered trademark of VIDEOR E. Hartig GmbH
Exclusive distribution through specialised trade channels only.
VIDEOR E. Hartig GmbH
Carl-Zeiss-Straße 8
63322 Rödermark/Germany
Tel. [phone] / 888-0
Fax [phone] / 888-100
www.videor.com
www.eneo-security.com
Technical changes reserved
© Copyright by VIDEOR E. Hartig GmbH
Version 10/2016