Eneo PM-42A User manual

55°
55°
26
10
49.1
76.5
190
154
Ø30
Pole Mount Adaptor
PRIOR to USE
PARTS SUPPLIED
DIMENSION SPECIFICATION
Install the mount onto a strong structure such as a concrete or steel beam, etc.
Use the supplied accessories when installing the mount to a structure, make sure
that all the screw parts are metallic.
Follow the mounting instructions based on the assigned marks to the camera
or mounting accessory in the Reference Section below.
Straps Mounting Screws
2.5mm, 3mm
M4x20
(unit: mm)
Construction:
Finish:
Environment:
Weight:
Steel
Light-gray Spray
Indoor/Outdoor for a pole like
structure (
Ø 100~200mm)
1.2kg (2.6 lb)
Mount Adaptor
Instruction Guide
WashersL-Wrench
Ø20
Wrench Bolt M4x20_FM
Please Turn Over

INSTALLATION
REFERENCE of MOUNTING HOLES
1. Feed the straps through the vertical slits located on the four corner of the mount adapter.
2. Wrap the straps around the pole then use the driver to rotate the screw that is attached at the ends of
the straps. Rotating the screw shorten the straps thereby fastening the mount around the pole.
3. Attach the cameras* to the pole mount adapter predetermined their mounting holes.
(*) Using the supplied screws with the camera packing you wish to mount.
Refer to the camera instruction manual for their mounting process.
eneo® is a registered trademark of
VIDEOR E. Hartig GmbH
Exclusive distribution through
specialised trade channels only.
VIDEOR E. Hartig GmbH,
Carl-Zeiss-Straße 8,
63322 Rödermark/Germany
Tel. [phone] / 888-0
Technical changes reserved
© Copyright by VIDEOR E. Hartig GmbH
Version 09/2017