Enigma C7 User manual

E N I G M A U S E R M A N U A L
FIAT ULYSSE BSI FROM 2006
FOR MORE INFORMATION
Call 0034 983 359 787 or visit www.enigmatool.com
DIAGCAR ELECTRONICS S.L. Ebanistería 1A, 47610 Zaratán, Spain
BSI AND LOCATION:
REQUIRED CABLE(s):
C7
FOLLOW THIS INSTRUCTION STEP BY STEP:
1. Remove the BSI module and open it carefully.
2. Solder cable C7 to the points on board as shown on PHOTO1.
3. Make sure that the connection you made is secure.
4. Use the EDITOR or READ EEP to save memory backup data.
5. Press the READ KM button and check if the value shown on the screen is correct.
6. Now you can use the CHANGE KM function.
PHOTO 1: Solder C7 cables according to the colors like shown on the photo above.

E N I G M A U S E R M A N U A L
FIAT ULYSSE BSI FROM 2006
FOR MORE INFORMATION
Call 0034 983 359 787 or visit www.enigmatool.com
DIAGCAR ELECTRONICS S.L. Ebanistería 1A, 47610 Zaratán, Spain
LEGAL DISCLAIMER:
DIAGCAR ELECTRONICS S.L. does not take any legal
responsibility of illegal use of any information stored in this
document. Copying, distributing or taking any action in reliance
with the content of this information is strictly prohibited.