Aries 2074142 User manual

PAGE 1 • 2074142-INS-RA • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Product Image
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
For black finishes, mild soap may be used to clean the product.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Level of Difficulty
Easy
Parts List
1Driver / left rocker step
1Passenger / right rocker step
12 Flat washer, M8
12 Nylock nut, M8
Tools Required
Torque wrench Socket, 13mm
Scan
for helpful
install tips
Front
Rear
INSTALLATION MANUAL 2074142
Torque Specifications
METRIC
M6 bolt 3 ft.-lbs.
M8 bolt 7 ft.-lbs.
M10 bolt 16 ft.-lbs.
M12 bolt 28 ft.-lbs.
SAE
1/4" bolt 3 ft.-lbs.
5/16" bolt 7 ft.-lbs.
3/8" bolt 16 ft.-lbs.
7/16" bolt 20 ft.-lbs.
1/2" bolt 28 ft.-lbs.

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 2074142-INS-RA • PAGE 2
Step 1
Starting on the driver side,
locate the three mounting points
located underneath the vehicle.
Step 2
Locate the front mounting point.
With help, lift the rocker step up to
the vehicle and secure using two M8 flat
washers and two M8 nylock nuts.
Snug the hardware,
but do not fully tighten.
Step 3
Repeat step 2 to attach the middle
and rear mounting brackets.
With the rocker step in position,
tighten all mounting hardware to the
recommended torque specifications
listed in the table on the first page.
Step 4
Repeat steps 1 through 3
on the passenger side of the vehicle.
Congratulations on the installation
of your new ARIES rocker steps.
With the rocker steps installed,
periodic inspections should be
performed to ensure all mounting
hardware remains tight.