EnviroGuard PRO X User manual

User Manual
The Science of Air Quality
V1.1

Precautions for setting up and using your device
Safety Precautions & Warnings

Safety Precautions & Warnings
IMPORTANT:
Prior to installation and use of the EnviroGuard PRO X™ device please read this quick start guide carefully
and save it for future reference. Keep EnviroGuard Purox™ Gel and EnviroGuard PrimeProtect™ Filter out of
reach of children.
DISCLAIMER:
The EnviroGuard PRO X™ is not a medical device and is not intended to prevent, alleviate or treat
respiratory illness or infection.
DANGER:
DO NOT clean the device with water, any other liquid, or a flammable detergent, nor let them enter the
device, to avoid electric shock and/or fire hazard.
DO NOT spray any flammable materials such as insecticides or fragrances around the device.
When removing and/or installing the EnviroGuard PrimeProtect™ Filter and/or EnviroGuard Purox™ Gel it
is recommended to wear safety glasses and gloves for safe handling.
EnviroGuard Purox™ Gel causes serious eye damage. It is a skin irritant and may be harmful if swallowed.
Avoid contact of gel with eyes and skin. Wear eye protection and protective gloves when handling. Refer to
SDS for other safety information.
EnviroGuard Purox™ Gel is an irritant. Avoid contact of gel with eyes and do not swallow. Refer to SDS for
other safety information.
EnviroGuard PrimeProtect™ Filter causes serious eye irritation. It is a skin irritant and toxic to aquatic life.
Avoid contact of the filter with eyes and skin. Wear protective gloves when handling. Refer to SDS for other
safety information.
WARNINGS:
Check if the voltage indicated on the device corresponds to the local power power voltage before you
connect the device.
DO NOT use the device if the plug, the power cord, or the device itself is damaged.
If the power cord is damaged, contact EnviroGuard Pty Ltd for replacement.
The device is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the device.
DO NOT block the air inlet or outlet, by placing items on the air outlet or in front of the air inlet.
Make sure that foreign objects do not fall into the device through the air outlet.
CAUTION:
This device is not a substitute for proper ventilation, regular vacuum cleaning, or use of an extractor hood
or fan while cooking.
Always place and use the device on a dry, stable, level and horizontal surface.
Leave at least 20cm free space around the device and leave at least 30cm free space above the device.
4

DO NOT sit or stand on the device.
DO NOT place anything on top of the device.
To avoid a hazard DO NOT use the device with an external switching device such as a timer, or
connected to a circuit that is regularly switched on or o.
DO NOT place the device below an air conditioner to prevent condensation from dripping onto the
device.
Only use the EnviroGuard PrimeProtect™ Filter designed specifically for this device.
Avoid knocking against the device (the air inlet and outlet in particular) with hard objects.
DO NOT insert fingers or objects into the air outlet or the air inlet to prevent physical injury or
malfunctioning of the device.
Always unplug the device when moving and cleaning.
DO NOT use device in wet surroundings or in surrounds with high humidity, high ambient tempera-
tures, such as bathrooms, toilets, kitchens or rooms with major temperature fluctuation.
CONSUMABLES DISPOSAL:
EnviroGuard Purox™ Gel
Please note there will be residue remaining in the gel cartridge - place the lid of the new replacement
gel cartridge onto the old gel cartridge before disposal.
EnviroGuard PrimeProtect™ Filter
Dispose of filter unit in a sanitary landfill, or by incineration, if allowed by State or local authorities. If
incinerated, stay out of the smoke area. Do not contaminate water, food or feed. Do not vacuum, wash
or spray clean the filter for reuse.
FIRST AID:
For Enviroguard Purox™ Gel
If swallowed - DO NOT induce vomiting, rinse mouth and get medical help if you feel unwell.
If in eyes - hold eyelids apart and flush the eye continuously with running water, remove contact lenses
if present and easy to do so. Continue flushing until advised to stop by a Poisons Information Centre or
a doctor, or for at least 15 minutes.
If skin or hair contact - remove contaminated clothing and flush skin and hair with running water.
If breathing is dicult - remove to an area of fresh air. If experiencing respiratory symptoms: Call a
doctor / physician.
For Enviroguard PrimeProtect™ Filter
If in eyes - Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy
to do so. Continue rinsing. If eye irritation persists, get medical advice/attention.
If on skin - Wash with plenty of water. If on clothing, take o contaminated clothing and wash before
reuse. If skin irritation persists: Get medical advice/attention.
For advice, contact a Poisons Information Centre (Australia 13 11 26; New Zealand 0800 764 766) or a
doctor at once.
5

Everything you need to get your device setup
Setting up EnviroGuard PRO X™

1
2
3
4
5
6
Product Overview
Setting up EnviroGuard PRO X
TM
Get familiar with your EnviroGuard PRO X™ device.
PrimeProtect™Filter Door
Use to replace PrimeProtect™ Filter.
EnviroGuard PRO X™Lid
Use to replace Purox™ Gel and adjust evaporation rate.
Power Cable
Use to plug EnviroGuard PRO X™ to a power supply.
Purox™Gel Evaporation Indicator
Set the amount of Gel that is evaporated into the air.
Halo Light Ring
Indicates air quality and information about the device.
Manual Controls
Tactile push buttons to operate the device.
8

Purox
TM
Gel
Evaporation Indicator
Manual Controls
Power Cable (behind)
PrimeProtect
TM
Filter Door
EnviroGuard PRO X
TM
Lid
Halo Light Ring
1
2
3
4
5
6
9

PrimeProtectTM Filter
Setting up EnviroGuard PRO X
TM
IMPORTANT: Upon purchase each EnviroGuard PRO X™ device comes
with an EnviroGuard PrimeProtect™ Filter preinstalled.
Please note: Replacement EnviroGuard PrimeProtect™ Filters can be
purchased through your EnviroGuard PRO X™ supplier of choice.
1
10

11

Remove EnviroGuard PRO X
TM
Lid
Gently push down and rotate
anti-clockwise until released.
Remove Purox
TM
container lid
Remove container lid carefully to
reveal gel. DO NOT touch gel.
Purox™ Gel Setup
Setting up EnviroGuard PRO X
TM
IMPORTANT: Prior to handling the EnviroGuard Purox™ please wear
protective gloves and eyewear. Wash hands after handling.
2
12

Insert open container into
Purox
TM
chamber
DO NOT pour contents into
Purox™ gel chamber.
Place EnvioroGuard PRO X
TM
Lid back onto device.
Push down gently and rotate
clockwise to lock into place.
Wash hands once complete.
13

Plug in device
Connect device to a power
source.
Press Power Button
The device will turn on.
EnviroGuard Pro X™ Device Setup
Setting up EnviroGuard PRO X
TM
Turning on your device and connecting to the EnviroGuard App.
3
14

Download the App
Download EnviroGuard App
from App Store or Google play.
Connect App with device
Hold Mode and Plus for
3 seconds to connect
via Bluetooth.
15

Control and Monitor
Using EnviroGuard PRO X™

Low
Medium
High
Change
Rotate Lid to change between evaporation
Lowest evaporation
Medium evaporation
Highest evaporation
18
Purox™ Gel
Evaporation Indicator
Using EnviroGuard PRO X
TM
The EnviroGuard PRO X™ Lid along with fan speed determines the
evaporation rate of the Purox™ Gel by the device. In general, the highest
evaporation rate equates to high reduction in airborne and surface
pathogens.
When first turning on your EnviroGuard PRO X™ device, it is good
practice to have the evaporation set to the highest level to achieve the
desired reduction of airborne and surface pathogens. You can turn this
setting down as required.
Rotate the EnviroGuard PRO X™ Lid anti-clockwise to change between
evaporation rates.
4

Evaporation Indictator
19

Good
OK
Poor
Alarms - Continuous Flashing
Green
Orange
Red
Air Quality
Door Open Flashing Aqua
Pro X Lid Fitted Incorrectly
Flashing Yellow
Change Consumables - Intermittent Pulsing
Change Filter
Pulsing Aqua
Low Gel
Pulsing Yellow
Bluetooth Pairing
Spinning Blue
Missing Filter
Flashing Aqua
20
Halo Light Ring
Using EnviroGuard PRO X
TM
The EnviroGuard PRO X™ Halo Light Ring illuminates with a white spin
automatically when the device is turned on. It then becomes a solid colour
based on air quality.
The Halo Light Ring also gives you visual signals about your device.
Please note that alarms aect the functionality of the device and must be
addressed immediately.
5