
1.Connect the HDMI video source output port to the
splitter input port by HDMI cable.
2.Connect the splitter output port to the HDMI display by
HDMI cable.
3.Set the TV input to right HDMI channel.
4.Power on the splitter (power indicator led will light on ).
4. Operation notes :
4.1 Before output HDMI signal,the splitter will read EDID
information of connected TVs and send it back to HDMI
source part to let it determine the output mode.
4.2 If there is HDMI signal input,the LED lights
blue,otherwise,LED lights red.
4.3 The indicator led shows the working status.
4.4 Please use 5V power supply only,otherwise,the
splitter will be damaged.
5. Trouble shooting
5.1 No image output
A .Check and make sure all connections are good and
correct.
B. Check and make sure the RV has been set up to the
right channel.
C. Check and make sure the corresponding splitter
output LED lights on.
D. Check if there is a output signal from HDMI resources
(If the splitter input signal source is from PC or Laptop,
please make sure the output mode of PC or Laptop is
copy or extend.)
5.2 Display is unstable,splash screen,snowflakes or
audio stuck
A.Check and make sure all connections are good and
correct.
B.Use HDMI cable supporting 4Kx2K when transmitting
4Kx2K HDMI signal.
6. Specification
Power supply
Input ports
Output ports
Power Port
Power/Signal indicator led
Signal indicator led
Frequency Range
Max Transmission rate
Color depth
AudioSupport
HDMI resolution
Dimension
Net weight
Color
Working temperature
DC 5V / 2A
HDMI X 1
HDMI X 4
DC 2.1mm X 1
Red/Yellow LED X 1
Blue LEDX 4
25MHz-340MHz
3.4G X 3=10.2Gbps
Supports 12-bit Deep Full HD.
Full 3D and 4Kx2K video
Support standard audio and
DSD ( Direct Stream Digital )
Audio and HD (HBR)Audio
480i@60Hz, 480P@60Hz,
576i@50Hz,576P@50Hz,
720P@50Hz/60Hz,1080i@50Hz/60Hz,
(720P@50Hz/60Hz,1080P@24Hz)
3840 x 216P@24Hz/25Hz/30Hz
158X78X18mm
270g
Black
0-60℃
1080P@50Hz/60Hz, 3D HDMI