Epcom EPS20EW User manual

Installaon manual for wall mounng for flat screen. EPS20EW
Note: It is recommended that this product be installed only by a professional. We do no accept
responsibility for damages caused by improper installaon, assembly or use of this equipment. In
case of any doubt, please contact a professional to help you.
IMPORTANT.
•For safety reasons, the wall or mounng surface must be able to support the combined
weight of the mounng and the screen; otherwise the structure must be reinforced.
Appropriate safety equipment and tool must be used. Failure to do so may result in •
property damage or serious injury.
Make sure electrical wires, water pipes or gas pipes are not located between the wall. •
Tools required for installaon
•Screwdriver cross head.
•Electric or portable drill.
•1/5”(5mm) drill bit + post detector (plaster wall installaon)
•2/5”(10mm) concrete drill bit (concrete installaon)
Make sure all installaon accessories are included with the assembly. You can find the following:
Wall Installaon
(A) M6x50 Delay Bolt
(D) M4x12 Bolt
(G) Adjustable spanner
(B) Anchor
(E) M6x12 Bolt
(C) Washer M6
(F) M8x12 Bolt
Plaster Wall Concrete Wall
Pole
Pole detector Measuring Tape Measuring Tape
Use a pencil to mark the holes Use a pencil to mark the holes
Insert a concrete hole in each hole

Place the screws on the screen
To adjust lt or rotate the screen, firmly hold
the sides of the screen and carefully move it to
its posion