Epcom EPS710FW User manual

Installaon manual for wall mounng for flat screen. EPS710FW
Note: It is recommended that this product be installed only by a professional. We do no accept
responsibility for damages caused by improper installaon, assembly or use of this equipment.
In case of any doubt, please contact a professional to help you.
IMPORTANT.
•For safety reasons, the wall or mounng surface must be able to support the combined
weight of the mounng and the screen; otherwise the structure must be reinforced.
Appropriate safety equipment and tool must be used. Failure to do so may result in •
property damage or serious injury.
Make sure electrical wires, water pipes or gas pipes are not located between the wall. •
Tools required for installaon
•Screwdriver cross head.
•Electric or portable drill.
•1/8”(3mm) Drill bit + pole detector (plaster wall installaon)
•5/16”(8mm) Concrete drill bit (concrete installaon)
Make sure all installaon accessories are included with the assembly. Included:
Wall Installaon
(A) Plaster screw
(C) M4x12 Bolt
(B) Anchor for screws
(D) M4x25 Bolt (E) Small spacer
Plaster Wall Concrete Wall
Pole Detector Measuring Tape
Pole
Measuring Tape
Use a pencil to mark the holes Use a pencil to mark the holes
Insert a concrete hole in each hole

M4x12 Bolts (C)
Flat back screens
Screens with curved back
Tighten or loosen the lt knob to
adjust the desired lt
Screens with flat back
Screens with curved back
For addional safety, use the M4x12
bolt to hold the plates together.